HEAD 1125737 - Caterpillar

Illustration 4 g01186753
Activate the switch (hydraulic lockout). The display should show "10_ _04".
Illustration 5 g01186439
Control Levers (1) DUMP position (2) LOWER position (3) Auxiliary FORWARD position (4) TILT BACK position (5) RAISE position (6) Auxiliary REARWARD positionNote: For additional information on control levers and joystick control, refer to Operation and Maintenance Manual, "Operator Controls" for the machine that is being serviced.
Verify that the lift lever is in the HOLD position.
Toggle the "Clear" switch. The display should show "10_ _05".
Place the lift control lever into the full RAISE position and hold.
Toggle the "Clear" switch. The display should show "10_ _06".
Place the lift control lever into the full LOWER position and hold.
Toggle the "Clear" switch. Release the control lever and allow the control lever to return to the HOLD position. The display should show "10_ _- -". The calibration of the lift lever was successful.
Enter the calibration mode for the tilt lever position sensor. Toggle the "Scroll" switch. The display should show "82_ _11".
Toggle the "Clear" switch. The display should show "11_ _02". Note: If the parking brake is set the display will show "11_ _03". If the parking brake is not set, then go to Step 17. If the parking brake is set and the switch (hydraulic lockout) is engaged the display should show "11_ _04". Go to Step 19.
Set the parking brake. The display should show "11_ _03".
Activate the switch (hydraulic lockout). The display should show "11_ _04".
Verify that the lift lever is in the HOLD position.
Toggle the "Clear" switch. The display should show "11_ _05".
Position the lever for the tilt back control into the full TILT BACK position and hold.
Toggle the "Clear" switch. The display should show "11_ _06".
Place the tilt control lever into the full DUMP position and