HEAD 1513190 - Caterpillar

Illustration 3 g06058342
Right Operator Display
(26) Operator display
(27) Material feed iconEach instrument panel is equipped with operator display (26). The display communicates with the ECMs on the machine through CAN"A" communication lines.Material feed icon (27) allows the operator to access the material feed functions of the operator display.
Illustration 4 g06058347
Material Feed Display Screen
(28) Conveyor speed
(29) Conveyor setpoint
(30) Auger speed
(31) Auger setpointThe material feed screen on the active tractor display allows the tractor operator to monitor and control the operations of the material feed system.The operator can use the display to monitor the following information:
Conveyor speed (28)
Conveyor setpoint (29)
Auger speed (30)
Auger setpoint (31)Conveyor speed (28) is displayed in rpm for the left and right conveyors. For machines configured with zero material height sensors, the conveyors operate in open-loop mode. Conveyor speed is adjusted directly with the corresponding control dial.For machines configured with two material height sensors, conveyor setpoint (29) is displayed in percentage of the calibrated maximum setpoint. The conveyor setpoint is adjusted with the corresponding control dial.For machines configured with four material height sensors, conveyor setpoint (29) percentage value represents desired conveyor material height percentage. Material is measured at the rear of the conveyors.Auger speed (30) is displayed in rpm for the left and right augers. For machines configured with zero material height sensors, the augers operate in open-loop mode. Auger speeds are controlled directly by the corresponding incremental bar.For machines configured with two material height sensors, auger setpoint (31) is displayed in percentage of the calibrated maximum setpoint. Each value is adjustable with the associated incremental bar on the display screen.For machines configured with four material height sensors, auger setpoint (31) percentage value represents desired material height percentage. Each value is adjustable with the associated incremental bar on the display screen. Material is measured at the sensor locations.Note: The number of feeder sensors must be configured in the display. If sensors are plugged in but not configured, the sensor data will be ignored.
Illustration 5 g06057702
Material Feed Display Screen
(32) Conveyor speed
(33) Conveyor setpoint
(34) Auger speed
(35) Auger setpointThe screed is equipped with two operator displays. The material feed display screen is similar to the tractor. However, the conveyor and auger adjustment are different.Note: Each screed panel controls the associated side of the material feed system as where the panel is mounted.The operator can use the display to monitor the following information:
Conveyor speed (32)
Conveyor setpoint (33)
Auger speed (34)
Auger setpoint (35)Conveyor speed (32) is displayed in rpm for the left and right conveyors. For machines configured with zero material height sensors, the conveyors operate in open-loop mode. Conveyor speeds are controlled by the corresponding incremental bar on the display.For machines configured with two material height sensors, conveyor setpoint (33) is displayed in percentage of the calibrated maximum setpoint. The conveyor setpoint is adjusted with the corresponding incremental bar.For machines configured with four material height sensors, conveyor setpoint (33) percentage value represents desired conveyor material height percentage. Material is measured at the rear of the conveyors. Each value is adjustable with the associated incremental bar on