HEAD-RATCHET 1613983 - Caterpillar

Illustration 1 g01795435
(1) 6E-0781 Sleeve Bearing Quantity ... 2 Inside diameter ... 130.32 0.02 mm (5.131 0.001 inch) Outside diameter ... 154.270 0.013 mm (6.0736 0.0005 inch) Installation depth of the sleeve bearing in the cap assembly ... 10.0 0.3 mm (0.39 0.01 inch) Installation depth of the sleeve bearing in the rod assembly ... 10.00 0.50 mm (0.394 0.020 inch) (2) Lubricate four lip type seals lightly with the lubricant that is being sealed.Note: Apply molybdenum disulfide to the threads of the locknut. (3) Torque for the locknut ... 13500 700 N m (9960 520 lb ft) (4) Lubricate the inside diameter and the outside diameter of three rings with clean grease. (5) Lubricate the inside diameter and the outside diameter of the seal assembly with clean grease. (A) Diameter of the rod assembly ... 139.930 0.030 mm (5.5090 0.0012 inch) (B) Bore of the cylinder assembly ... 200.000 0.025 mm (7.8740 0.0010 inch) (C) Bore of the head over two lands ... 140.630 0.030 mm (5.5366 0.0012 inch) (6) Free linear movement of the stop after assembly ... 0.50 0.26 mm (0.020 0.010 inch) (7) Maximum outside diameter of two retaining rings after assembly ... 91.5 mm (3.60 inch) (8) The slit of the seal ring must turn in the direction of the piston. (9) Torque for 11 bolts ... 900 100 N m (660 75 lb ft) (10) 128-9261 Sleeve Bearing Outside diameter ... 145.153 0.033 mm (5.7147 0.0013 inch) Thickness ... 2.475 0.025 mm (0.0974 0.0010 inch) (11) Lubricate the sealing lip of the buffer seal lightly with the lubricant that is being sealed. (12) Lubricate the sealing lip of the U-cup seal lightly with the lubricant that is being sealed. (13) Lubricate the sealing lip of the lip type seal lightly with the lubricant that is being sealed. (14) Before assembly, apply 4C-4032 Bearing Mount Compound to the groove of the wiper seal.