HEAD 3149337 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01304820
Typical example
Loosen nut (2) that attaches the clip on oil line (1) to the fuel injection pump.
Remove banjo bolt (3) and remove washers (4) from the cylinder block.
Illustration 2 g01307372
Typical example
Remove banjo bolt (5) and remove washers (6) from the cylinder head.
Remove oil line (1) from the engine.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01304820
Typical example
Place oil line (1) on the engine. Ensure that the clip on the oil line is located below nut (2).
Position banjo bolt (3) and new washers (4) onto oil line (1). Install the banjo bolt and oil line to the cylinder block finger tight.
Illustration 4 g01307372
Typical example
Position banjo bolt (5) and new washers (6) onto oil line (1). Install the banjo bolt and the oil line to the cylinder head finger tight.
Tighten nut (2) that attaches the clip on oil line (1) to the fuel injection pump.For the C1.1 engine, tighten nut (2) to a torque of 6 N m (53 lb in).For C1.5 and C2.2 engines, tighten nut (2) to a torque of 15 N m (133 lb in).
Tighten banjo bolts (3) and (5) to a torque of 12 N m (106 lb in).