HEAD 5221194 - Caterpillar

5221194 HEAD Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5221194
522-1194
5221194

Weight: 29 pounds 13 kg.

Buy HEAD 5221194 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 3

For full view, you need register

Information:

Illustration 20 g06120491
(34) Existing Mounting
(35) New Mounting
Install elbow (3), O-ring (29), and plug (30).
Install cover (6) with bolt (2), washer (7), and O-ring (31).
Install new SCAC tube (32) with O-ring seal (22) , ring (23), and adapter (33).
Illustration 21 g06120493
(7) 5M-2894 Hard Washers
(34) 109-7411 O-Ring Seal
(35) 348-7062 Seal
(36) 3B-1915 Bolts
Install inlet cover with seal (35), bolts (36), washers (7), and O-ring (34).
Toque bolts (36) to 47 N m (35 lb ft).
Illustration 22 g06120497
(7) 5M-2894 Hard Washers
(28) 0S-1588 Bolts
(34) 109-7411 O-Ring Seals
(37) 122-3374 Elbows
Install inlet elbows (37) with O-rings (34), bolts (28), and washers (7).
Torque bolts (28) to 47 N m (35 lb ft).
Illustration 23 g06120499
(9) 9X-6458 Hard Washers
(38) 444-7311 Air Pipe
(39) 444-7312 Air Pipe
(40) 6V-5103 O-Ring Seal
(41) 112-1567 Strap
(42) 0S-1594 Bolt
Install compressor pipe (38) to the left inlet elbow with O-ring (40), washers (9), strap (41), and bolts (42).
Install compressor pipe (39) to the right inlet elbow with O-ring (40), washers (9), strap (41), and bolts (42).
Illustration 24 g06120504
(8) 9S-8752 Full Nuts
(9) 9X-6458 Hard Washers
(12) 0S-1571 Bolts
(42) 0S-1594 Bolts
(43) 396-3369 Bracket
(44) 396-3370 BracketNote: Remove paint from area where the bolts and washers will rest.
Install brackets (43) and (44) with nuts (8), washers (9), bolts (12), and bolts (42).
Illustration 25 g06088056
Loosen the bolts on the compressor housing and rotate the housing upward 7 degrees. Leave bolts loose until final assembly, then torque to 40 3 N m (30 2 lb ft).
Illustration 26 g06120506
(45) 344-0079 Bellows As
(46) 434-6544 V Band Clamp
Install new bellows (45) with v-band clamps (46).
Apply anti-seize to the threads, bearing surfaces and the inner surface of the clamp assemblies.
Tighten v-band clamps (46) to a torque of 7.5 1 N m (66 9 lb in). Lightly tap around the diameter of the clamp assemblies with a soft hammer. Then retorque clamp (46) to 7.5 1 N m (66 9 lb in).
Illustration 27 g06043238
Finished Assembly