HEAD 6E6485 - Caterpillar

Illustration 8 g06150922
Remove the plug from port "M5" (12) on the left side of the pump. Install one Tool (G) in port "M5". Tighten Tool (G) to a torque of 12 N m (9 lb ft).
Connect Tool (C) to Tool (G) in port "M5" (12).
Illustration 9 g06150930
Remove the plug from Port "M4" (13) on the right side of the pump. Install other Tool (G) in port "M4". Tighten Tool (G) to a torque of 12 N m (9 lb ft).
Connect Tool (C) to Tool (G) in port "M4" (13).
Illustration 10 g06150947
Connect Tool (K) and Tool (L) to Tool (J). Connect Tool (K) to diagnostic connector (14). Connect Tool (L) to USB port on Tool (H).
Move engine start switch (8) to the START position. Release the switch when the engine starts.
Operate the hydraulic system until the oil temperature reaches the test temperature of 45 °C (113 °F).
Place the engine in ECO or low