HEAT EXCHANGER GP-SEA WATER 1071730 - Caterpillar

Oil Filter Base
1. Drain the oil from the oil cooler. 2. Use tool (A) and remove oil filter (1) from the oil filter base. 3. Remove four bolts (2) that hold the oil filter base cylinder block. 4. Remove bolts (3) that hold oil filter base (4) to the cylinder block. Remove bolts (5) that hold oil filter base (4) to the oil cooler and remove oil filter base (4) from the engine. 5. Remove seals (6) from the oil filter base.Install Oil Filter Base
If the stud was removed from the oil filter base, put 9S3263 Thread Lock on it 7.62 mm (.30 in.) from the taperlock end. Install the stud in the oil filter base and tighten it to a torque of 80 14 N m (60 10 lb.ft.).1. Inspect the seals for wear or damage and make a replacement if necessary. 2. Put seals (1) into position on oil filter base (2).3. Install oil filter base (2) on the oil cooler. 4. Install bolts (3) that hold the oil filter base to the cylinder block. 5. Put clean oil on the filter gasket. Install oil filter (4) on the oil filter base. Tighten the filter 3/4 of a turn after the filter gasket makes contact with the filter base.6. Check the oil level in the engine. See MAINTENANCE GUIDE.Disassemble Oil Filter Base
START BY:a) remove oil filter base Spring force is present behind covers (1).1. Remove the bolts and covers (1) from the oil filter base. 2. Remove springs (2) and valves (3) from the oil filter base. 3. If necessary remove stud (4) from the oil filter base.Assemble Oil Filter Base
1. Use 9S3263 Thread Lock on stud (1) 7.62 mm (.30 in.) from the taperlock end.2. Install stud (1) in oil filter base. Tighten the stud to a torque of 80 14 N m (60 10 lb.ft.). 3. Install valves (2) and springs (3) in the oil filter base. 4. Install covers (4) on the oil filter base.END BY:a) install oil filter base