HEAT SHIELD-BAND 2389981 - Caterpillar

Illustration 1 g01405580
Table 1
Specification for 213-3193 Connecting Rod
Item Qty Part Specification Description
A 1 211-0595 Connecting Rod Handle the fractured connecting rod with care. Use a soft jawed vise in order to hold the connecting rod while loosening the connecting rod cap bolts. Use a soft faced hammer in order to tap the connecting rod cap, if necessary.
Bore for piston pin bearing is 43.191 0.013 mm (1.7004 0.0005 inch).
B 1 2W-0027 Bearing After installation, bore in the bearing is 40.028 0.008 mm (1.5759 0.0003 inch).
C - - The bearing joint for the piston pin bearing must be positioned to the angle above the centerline on either side is 12 5 degrees.
D - - Before installation of the piston pin bearing, connecting rod small end must be heated from 175 to 260 °C (347 to 500 °F).
Distance for heating the connecting rod for the installation of the piston pin bearing is 75 5 mm (3.0 0.2 inch).
E - - Distance between the center of the connecting rod bores is 200 mm (7.9 inch).
F - - Bore in the connecting rod for the bearing for the crankshaft connecting rod journal is 75.000 0.013 mm (2.9527 0.0005 inch).
G 2 229-6266 Bolt Length of the bolt is 65.0 0.5 mm (2.56 0.02 inch).
- - - Use the following procedure to tighten the connecting rod bolts:
1. Before installing the rod cap, clean the mating surfaces of the connecting rod with compressed air or a steel brush.
2. Lubricate the seating faces of the cap with 4C-5599 Anti-Seize Compound or clean engine oil .
2. Install new bolts (1) and torque each bolt to 70 5 N m (50 4 lb ft).
3. Place an index mark on each connecting rod cap bolt and tighten each bolt for an additional turn of 120 5 degrees.