HEAT EXCHANGER GP-SEA WATER 4953931 - Caterpillar

Introduction
The following procedure will describe the steps that are required in order to remove the stabilizers from the machines that are listed above. This procedure is only suitable for machines that are supplied to the North American market. Reference: Operation and Maintenance Manual, SEBU7370, "TH62, TH63, TH82 and TH83 Telehandlers".Reference: Parts Manual, SEBP3131, "TH63 Telehandlers"Reference: Parts Manual, SEBP3133, "TH83 Telehandlers"Reference: Disassembly and Assembly, RENR3437, "Telehandlers Machine Systems"Parts that are required
Tables 1 and 2 contain the parts that are required after the removal of the stabilizers.
Table 1
List of Parts for TH63 Telehandlers    
Item     Qty     Part Number     Description    
1     1     167-1508     Counterweight    
2     2     7X-2570     Bolt    
3     4     8T-5439     Washer    
4     2     8T-4131     Nut    
5     1     196-8624     Plates and Films    
6     2     6V-9508     Face Seal Plug    
7     1     6V-9507     Face Seal Plug    
8     2     109-2356     Plug    
Table 2
List of Parts for TH83 Telehandlers    
Item     Qty     Part Number     Description    
1     1     167-1511     Counterweight    
2     2     198-6003     Bolt    
3     4     8T-5439     Washer    
4     2     8T-4131     Nut    
5     1     196-8630     Plates and Films    
6     2     6V-9508     Face Seal Plug    
7     1     6V-9507     Face Seal Plug    
8     2     109-2356     Plug    Removal of the Stabilizers
Refer to Disassembly and Assembly, "Stabilizer - Remove" for the information that is required in order to remove the stabilizers from the machine. Note: Plug the ports on the stabilizer valve in order to prevent dirt from entering the stabilizer valve.
Illustration 1 g00854690
Refer to Tables 1 and 2 for the list of components.
Install the counterweight (1) onto the machine. Refer to Disassembly and Assembly, "Counterweight - Remove and Install".
Install three face seal plugs (6) and (7) to the ends of the three hoses that were connected to the stabilizer valve. Refer to Tables 1 and 2.
Tape the electrical connectors that were connected to the solenoids on the stabilizer valve. The tape will prevent moisture or dirt from entering the connectors.
Pull the hoses and the electrical connectors inside the chassis. Secure the hoses and the electrical connectors inside the chassis. Ensure that the hoses and the electrical connectors are not in contact with any moving parts.
Illustration 2 g00854694
Instrument Panel
Remove the two switches for the stabilizers from the