HEAT EXCHANGER GP-SEA WATER 5145037 - Caterpillar

Crushing or Cutting Prevention
Support equipment and attachments properly when working beneath them. Do not depend on hydraulic cylinders to hold them up. An attachment can fall if a control is moved, or if a hydraulic line breaks.Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.Where there are attachment linkages, the clearance in the linkage area will increase or decrease with movement of the attachment.Stay clear of all rotating and moving parts.Keep objects away from moving fan blades. They will throw or cut any object or tool that falls or is pushed into them.Do not use a kinked or frayed wire rope cable. Wear gloves when handling wire rope cable.Retainer pins, when struck with force, can fly out and injure nearby persons. Make sure the area is clear of people when driving retainer pins.Wear protective glasses when striking a retainer pin to avoid injury to your eyes.Chips or other debris can fly off objects when struck. Make sure no one can be injured by flying debris before striking any object.Burn Prevention
Coolant
At operating temperature, the engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to remove with your bare hand.Remove the cooling system fill cap slowly to relieve pressure.Cooling system additive contains alkali that can cause personal injury. Avoid contact with the skin, eyes and mouth.Allow cooling system components to cool before draining.Oils
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact the skin.At operating temperature, the hydraulic tank is hot and can be under pressure.Remove the hydraulic tank fill cap only after the engine has been stopped and the fill cap is cool enough to remove with your bare hand.Remove the hydraulic tank fill cap slowly to relieve pressure.Relieve all pressure in air, oil, fuel or cooling systems before any lines, fittings or related items are disconnected or removed.Batteries
Batteries give off flammable fumes which can explode.Do not smoke when observing the battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear protective glasses when working with batteries.Fire or Explosion Prevention
All fuels, most lubricants and some coolant mixtures are flammable.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Do not smoke while refueling or in a refueling area.Do not smoke in areas where batteries are charged, or where flammable materials are stored.Batteries can be located in separate compartments. When using jumper cables always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal. (If not equipped with starter negative (-) terminal, connect to engine block.)See the Operation Section of this manual for specific starting instructions.Clean and tighten all