HEATER GP-MACHINE 2058586 - Caterpillar

Illustration 11 g06098282
(1) 9R-2613 Weld Boss
Illustration 12 g06105251
(A) 91.8 mm (3.61 inch)
(B) 24.3 mm (0.96 inch)
(C) 491.2 mm (19.34 inch)
(D) 43.7 mm (1.72047 inch)
(E) 210.8 mm (8.29 inch)
(F) New location of 9R-2613 Weld Boss
(W1) 6.0 mm (0.24 inch) all around fillet weld
Relocate boss (1) as per the dimension shown in Illustration 12.
Illustration 13 g06098649
(1) 9R-2613 Weld Boss
(G) Hose clip
Flip hose clips (G) to accommodate boss (1).
Illustration 14 g06098624
(2) 452-7209 Special Bushing
(3) 177-3484 Special Bolt As
(4) 496-8208 Tube
(5) 496-8209 Tube
(6) 496-8206 Bracket As
(7) 8T-4196 Bolt
(8) 8T-4121 Hard Washer
(9) 6V-7744 Locknut
(10) 251-2139 Bracket
(11) 8T-4200 Bolt
(12) 8T-4224 Hard Washer
(H) Dog bone link
Illustration 15 g06103387
(2) 452-7209 Special Bushing
(3) 177-3484 Special Bolt As
(5) 496-8209 Tube
(6) 496-8206 Bracket As
Install two bracket assemblies (6) per link with two bolts (7), four washers (8), and two locknuts (9).Connect tube (4) and tube (5) to dog bone link (H) using banjo fitting (2) and banjo bolt (3) per tube.Secure tube (4) and tube (5) with clamp brackets using three tube clamps (10) and secure with three bolts (11) and washers (12) as shown in Illustration 14 and Illustration 15.
Illustration 16 g06103382
(8) 8T-4121 Hard Washer
(13) 8T-4137 Bolt
(14) 496-8204 Bracket As
(15) 496-8203 Hose As
(16) 8T-1887 Clip
(17) 8T-1888 Clip
(18) 353-7957 Grommet
(19) 8T-4195 Bolt
(20) 6J-3958 Pipe Coupling
(J) Clipping point
On each lever, install bracket assembly (14) onto cross member and secure with bolt (13) and washer (8).
Attach two hose assembly (15) to bracket assembly (14). Clip hoses to the lever using two clips (16), two clips (17) and two grommets (18). Secure with two bolts (19) and two washers (8) per each hose.
Connect hose assembly (15) to tubes using pipe coupling (20) per connection.
Tape on hoses should be at the clipping point (J).