HEATER GP-JACKET WATER 2313054 - Caterpillar

Illustration 1 g00534624
This warning label is located in the operator compartment.
DO NOT OPERATE OR WORK ON THIS MACHINE UNLESS YOU HAVE READ AND UNDERSTAND THE INSTRUCTIONS AND S IN THE OPERATION AND MAINTENANCE MANUALS. FAILURE TO FOLLOW THE INSTRUCTIONS OR HEED THE S COULD RESULT IN INJURY OR DEATH. CONTACT ANY CATERPILLAR DEALER FOR REPLACEMENT MANUALS. PROPER CARE IS YOUR RESPONSIBILITY.
Do Not Weld on the ROPS
Illustration 2 g00507751
This warning label is located on the outside of the cab on the right side.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Certification for Rollover Protective Structure (ROPS) and for Falling Object Protective Structure (FOPS)When the ROPS or the FOPS is properly installed on a machine which is not altered to exceed the certification test mass, this structure meets the following standards at the time of installation: SAE J394, SAE J1040 APR88, ISO 3471-1:1986, ISO 3471:1994, SAE J231 JAN 81, ISO 3449:1992 LEVEL II.No Clearance
Illustration 3 g00534625
This warning label is located at the center pivot.
No clearance for person in this area when machine turns. Severe injury or death from crushing could occur.
Connect the steering frame lock between the front and the rear frame. Connect the steering frame lock before lifting. Connect the steering frame lock before transporting. Connect the steering frame lock before the machine is serviced near the articulation pivot.Disconnect steering frame lock and secure the steering frame lock before resuming operation.Do Not Step On Cleaner Bar
Illustration 4 g00507753
This warning label is located on each cleaner bar and in several locations near the cleaner bars.
Do not step on cleaner bar when machine is moving
Compressed Spring
Illustration 5 g00274388
This warning label is located on the parking brake actuator.
Do not attempt to remove spring(s), they are not serviceable. Do not cut, saw, torch or modify this chamber, serious injury or death may result.
Improper Connections Of The Jump Start Cable
Illustration 6 g00274389
This warning label is positioned under the cover for the battery compartment.
Improper jumper cable connections can cause an explosion resulting in personal injury. Batteries can be located in separate compartments. When using jumper cable always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal. (If not equipped with starter negative terminal, connect to engine block.)