HEATER GP-CAB 5068058 - Caterpillar

Illustration 9 g01228276
Typical Example
Apply a thin coat of oil to Tooling (A) and Tooling (B). Install Tooling (A) and leave the bolts loose. Install Tooling (B). Tighten the bolts for Tooling (A). Install Tooling (C). Use Tooling (C) in order to rotate the camshaft. Rotate the camshaft in order to remove the camshaft. Note: The camshaft can be removed from either end of the engine.
Illustration 10 g01228315
Remove camshaft (20) halfway from the engine. Use a suitable lifting device in order to support camshaft (20). The weight of camshaft (20) is approximately 95 kg (210 lb). Remove the remaining portion of camshaft (20). Installation Procedure
Illustration 11 g01228274
Typical Example
Illustration 12 g01228276
Typical Example
Note: The camshaft can be installed from either end of the engine.
Apply a thin coat of oil to Tooling (A) and Tooling (B). Install Tooling (B) into the ends of the camshaft. Install Tooling (C). Note: If, Tooling (A) was removed use the following Steps in order to install Tooling (A).
Install Tooling (B) into the engine until Tooling (B) is through the second camshaft bearing.
Slide Tooling (A) over Tooling (B).
Tighten the bolts for Tooling (A).
Remove Tooling (B).
Illustration 13 g01228315
Attach a suitable lifting device to the middle of camshaft (20). The weight of camshaft (20) is approximately 95 kg (210 lb). Install camshaft (20) halfway into the engine. Remove the suitable lifting device. Install camshaft (20). Use Tooling (C) in order to rotate camshaft (20). Rotate camshaft (20) in order to install camshaft (20).
Illustration 14 g03347756
Install housing assembly (19) and bolts (18).
Illustration 15 g03347763
Install housing (17). Connect hose assembly (16).
Illustration 16 g03347755
Install bracket assembly (15). Connect harness assemblies (14).
Illustration 17 g01228236
Install retainer (13). Install the washers and bolts (12).
Illustration 18 g03347879
Illustration 19 g01228235
Rotate the engine so that the number one piston is at top dead center on the compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston". Pin camshaft (20) with Tooling (D). Install cam gear (11). Install spacer (10). Install bolts (8). Remove pin from camshaft (20) and install bolt (9).
Illustration 20 g01228201
Install cover (7). Install bolts (6).
Illustration 21 g01228199
Install lifting bracket (5). Install bolts (4). Install cover (3). Install bolts (2). Connect harness assemblies (1).
Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct and filling procedures.