HEEL GP 1340763 - Caterpillar

Illustration 29 g03330894
Reinstall acoustics panel (M) which fits under the console cover.
Illustration 30 g03330924
Purple and black wires are connected at the arrow.
Illustration 31 g03340965
Attach two lights (13) to the console cover in the holes drilled previously. The lights should snap fit into the holes. The winch oil filter bypass light should be placed on the left looking from the top. Reinstall the right-hand console cover over the two handles. Connect the four wires to the two lights. The purple and black pair should attach to the winch oil filter bypass light. Each light is bipolar allowing the two wire ends to be connected in any pattern. Connect the warning light (G) .
Illustration 32 g03340967
Place film (14) directly above the two lights (toward the pillar). Place film (15) towards the window on top of the console cover.
Illustration 33 g03330888
(B) Communication port (C) Mounting plate
Illustration 34 g03330890
Reconnect the wiring for the switches, communications port, and 12V outlets. Attach the mounting plates for switches (D), communications port (B), and 12V outlets (C) using the fasteners and washers removed previously.
Illustration 35 g03330987
(F) Console cover (E) Horn knob
Fasten console cover (F) down using the fasteners and washers removed previously.
Install horn knob (E) .
Illustration 36 g03330989
(A) Armrest
Reinstall the right side armrest assembly (A) using the original bolts, washers, and knobs.
Install the seat.ReferenceDisassembly and Assembly, KENR8915, "Adjustable Seat"
Illustration 37 g03330990
On the rear of the tractor, route harness (16) under the fuel tank and along the right winch mounting bracket and connect the harness to the 31-pin connector on the exterior of the winch. Connect the opposite ends (12-pin and 4-pin) to harness (12) .Note: The fuel tank is turned off for clarity in the following Illustration.
Illustration 38 g03330993
Fasten ladder clip (3) to the boss on the right winch mounting bracket using bolt (4) and washer (5). Strap the harness to the clips using eight straps (6) .
Proceed to ""Installing the New Software"".Installing the New Software
Before installing the software, make sure that the tractor is in proper operating condition.
Turn the battery disconnect switch to the ON position.
Connect a computer with Cat ® Electronic Technician (Cat ET) Service Tool to the communications port in the cab.
Turn the ignition key to the ON position.
Flash 423-1029 Implement Software Gp or the most current software onto the tractor.
Illustration 39 g03343555
Use Cat ET to navigate to the "Configuration" page for the Implement ECM.
With in the Implement Configuration, change the "Rear Attachment Installation Status" to "Winch".
After the parameter is modified, disconnect Cat ET.
Cycle the ignition key and the battery disconnect.
Reconnect Cat ET in order to make sure that all configurations are saved.
Start the tractor and check for leaks and proper functionality of the winch attachment.