HINGE ASSEM. 1K9025 - Caterpillar

Attach a suitable lifting device to operator station. Raise the operator station in order to remove Tooling (A) .
Illustration 19 g01314503
Install the washers and bolts (23) .
Illustration 20 g01314494
Remove Tooling (A) and install bolts (22) .
Install bolts (21) .
Illustration 21 g01315794
Install bolts (20), the washers, and the nuts.
Illustration 22 g01314474
Insert harness assembly (15) and harness assembly (14) through the opening on the operator station. Pull hose assemblies (18) through the opening on the operator station. Lay harness assembly (15) and hose assemblies (18) onto cover assembly (17). Install the clamp, the washers, and nuts (19) .
Illustration 23 g01314471
Connect hose assemblies (18) .
Illustration 24 g01314175
Tilt cover assembly (17) backward and install screws (16) .
Illustration 25 g01314137
Connect harness assemblies (14) and (15) .
Illustration 26 g01314090
Install the clip, the washer, and nut (13) .
Illustration 27 g01314078
Install throttle valve (11), bolts (12), the washers, and the nuts.
Illustration 28 g01314074
Install set screw (10) and handle (9) .
Illustration 29 g01314003
Connect hose assemblies (8) to metering unit (7) .
Illustration 30 g01313997
Connect harness assemblies (4) and (6). Install cable strap (5) .
Illustration 31 g01313996
Tilt operator console (2) backward and install the washers and bolts (3) .
Illustration 32 g01313994
Install bolts (1) and the washers.
Connect the ground cable to the battery and close the hood.End By: Install the rollover protection structure. Refer to Disassembly and Assembly, "Rollover Protection Structure - Install".