HINGE 2061854 - Caterpillar

Illustration 22 g00459558
Use Tool (C) in order to install lip type seal (57) in the outer governor housing with the lip inward.
Install adjustment screw (58) and the locknut for the high idle adjustment.
Illustration 23 g00459560
Install check valve (59) .
Illustration 24 g00459562
Put lever (60) in position, as shown. Install shaft (61) .
Illustration 25 g00459564
Put the gasket and shutoff solenoid (62) in position and install two bolts (63) .
Put the gasket and cover (64) in position and install two bolts (65) .
Install body (66) and contact (67) .
Put the O-ring seal on adapter (68) and put the coupling and adapter (68) in position. Install two bolts (69) .
Illustration 26 g00459590
Install spring (70) in shaft assembly (71). Install pin (72) in shaft assembly (71). The tip of pin (72) should be engaged in the hole in spring (70). Install pin (73) in shaft assembly (71) in order to hold pin (72) in place.
Illustration 27 g00459593
Put stop (76) and plates (74) in position on shaft assembly (71) and install pins (75). Install snap rings (77) .
Illustration 28 g00459595
Put levers (79) and (78) in position in the housing, as shown. Install shaft assembly (71) .
Illustration 29 g00459596
Install low idle adjustment screw (81) and the locknut. Install spring (80) in the hole in the shaft assembly and in the housing.
Illustration 30 g00454486
Use Tool (C) in order to install lip type seal (82) in cover (83) with the lip, as shown. Install the seal so that the seal is 2.0 1.5 mm (.08 .06 inch) below the surface of the cover.
Illustration 31 g00459597
Put the gasket and cover (83) in position on the housing and install six bolts (84) .
Illustration 32 g00459598
Note: Ensure that seat (85) and spring (86) are on top of lever (79). These parts must be kept in this position when housing (87) is put in position on the inner governor housing.
Install seat (85) and spring (86) on the guide in the housing.
Illustration 33 g00459600
Put the gasket and housing (88) in position on the inner governor housing and install six bolts (87) and two bolts (89) .
Illustration 34 g00459667
Install fuel ratio control (90) onto governor (91) .
Make the governor adjustments. Refer to the Testing and Adjusting, "Fuel System" topic for more information on governor adjustments.End By: Install the fuel injection pump housing and the governor. Refer to the Disassembly and Assembly, "Fuel Injection Pump Housing and Governor - Install".