AVSPARE.COM
parts catalog

HINGE 3728246 - Caterpillar



3728246 HINGE Caterpillar parts C15, C27 HINGE
Rating:
53
Alternative (cross code) number:
CA3728246
372-8246
3728246
Caterpillar 3728246 HINGE
Weight: 6 pounds 2 kg.

Buy HINGE 3728246 Caterpillar genuine, new aftermarket tractor parts with delivery
GENERATOR SET,

Compatible equipment models: 3728246:

GENERATOR SET  C15   C27   Caterpillar
Number on catalog scheme: 20
 
  For full view, you need register

Information:


Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
The hydraulic oil in this system is SAE 10W. If the oil becomes contaminated, premature component failure could result. Contaminated oil can also contribute to overheating. Use the following procedure to sample the oil in the hydraulic system.
Illustration 1 g00899335
Left Side of the Machine
Illustration 2 g00912078
Right Side of the Machine
Remove the side cover on the earlier models. Open the access door on the newer models.
Start the engine and run the engine at high idle.
Actuate all cylinders through a minimum of ten full cycles.
Lower all attachments to the ground and run the engine at low idle.
Illustration 3 g00899325
Earlier Models (1) Hydraulic oil sampling port. (2) Implement pump.
Illustration 4 g00912079
Newer Models (1) Hydraulic oil sampling port. (3) Case drain filter.
Locate hydraulic oil sampling port (1). The oil sampling port is located near implement pump (2) on the earlier models. The oil sampling port is located on the base of case drain filter (3) on the newer models. The case drain filter is mounted on the hydraulic tank.
Purge hydraulic oil sampling port (1). Insert an 8T-9208 Probe Assembly into hydraulic oil sampling port (1). Note: Use approximately 150 mm (6 inch) length of tube on the end of the probe. Drain approximately 100 mL (4 fl oz) of oil into a container for disposal. This will clean out the sampling port so that a good oil sample may be obtained.
Use a clean tube to draw a 100 mL (4 fl oz) oil sample from the fluid sampling valve. Use an 8T-9190 Fluid Sampling Bottle in order to take the hydraulic oil sample.Reference: Refer to Special Publication, PEHP6001, "How To Take A Good Oil Sample" for information about obtaining an oil sample.
The level of contaminants must be lower than the values in the following table.
Table 1
Hydraulic Oil Contamination    
Particle Size (Microns)     Maximum Number of Particles    
10 to 20     48000    
21 to 50     2580    
51 to 100     150    
100 or more     20    
Stop the engine. Install the cover.

Caterpillar parts catalog:

Caterpillar parts catalog
XQ500 Power System GG500001-UP POWERED BY C15 Engine
C15 Rental Generator Set X5M00001-UP POWERED BY C15 Engine
C27 Rental Generator Set N1B00001-UP
XG400 CG137–12 Power Module AL500001-UP


Parts hinge Caterpillar catalog:

3175796 HINGE AS
C13 XQ350, C15, C27
2675648 HINGE
C2.2, C4.4, C6.6
7G4262 HINGE
227, 627B, 637D, 938H, C175-16, C175-20, D6H, D6H XL, D6R, D6R II, D6R III, D6R STD, D6T, D6T LGP, D6T XL, D8N, D8R, D8R II, D8T
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.