HINGE AS 3C8418 - Caterpillar

The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
The alignment of the bellows is important. Improper alignment may lead to premature failure of the bellows. Misalignment can be identified by visually inspecting the convolutions for uniformity of compression.Inspect the bellows for damage prior to installation. If there is any damage to the convolutions, discard the bellows. Minor damage to the ends of the bellows may be repaired. However, if there is any difficulty in installation after the repair, discard the bellows.
Illustration 1 g01352766
Right side of engine (1) Torque for band clamps ... 8 3 N m (70 27 lb in) (A) Angle of the band clamp ... 15 10 degrees (2) Air inlet elbow