HITCH GP-ARTICULATING 3967673 - Caterpillar

Bucket Lift Lever
Single Lever Attachment Control (If Equipped). Float (1) - Push the lever all the way forward into detent, for FLOAT. The bucket will lower to the ground, and move up and down, following the ground contour.The lever will remain in FLOAT until pulled out of detent. The lever will then return to HOLD when released.
NEVER use FLOAT position to lower a loaded bucket.Machine damage can result from bucket falling too fast.
LOWER (2) - Push the lever forward to lower the bucket. The lever will return to HOLD when released. HOLD (3) - The lever will return to HOLD when released from either RAISE or LOWER. The bucket will remain in the position it is in. RAISE (4) - Pull the lever back to raise the bucket. Release the lever to stop lifting the bucket. The lever will return to HOLD when released.The lever is detented in the full raise position. It will stay in detent and continue raising, until the bucket reaches height set by the lift kickout. Then it returns to HOLD.Bucket Tilt Lever
Standard Lever
DUMP (1) - Push the lever forward to dump the bucket. HOLD (2) - Release the tilt lever. The bucket will remain in the position it is in. TILT BACK (3) - Pull the lever back to tilt the bucket back.The lever is detented in the full tilt back position. It will stay in detent and continue tilting back, until the bucket reaches the present digging angle set by the kickout. Then it returns to HOLD. If equipped with ride control system, the lift arms may partially lower when the tilt lever is held in the DUMP position with the bucket against the dump stop and the lift arms are in the FULL RAISED position. To avoid lift arm lowering after dumping the bucket, return the tilt lever to the HOLD position.Single Lever Attachment Control (If Equipped)
Single Lever Attachment Control (If Equipped). DUMP (1) - Push the lever to position (1) to dump the bucket. HOLD (2) - Release the tilt lever. The bucket will remain in the position it is in. TILT BACK (3) - Push the lever to position (3) to tilt the bucket back.The lever is detented in the full tilt back position. It will stay in detent and continue tilting back, until the bucket reaches the present digging angle set by the kickout. Then the lever returns to HOLD. If equipped with ride control system, the lift arms may partially lower when the tilt lever is held in the DUMP position with the bucket against the dump stop and the lift arms are in the FULL RAISED position. To avoid lift arm lowering after dumping the bucket, return the tilt lever to the HOLD position.Multipurpose Bucket Bowl Lever
Single Lever Atachment Control (If Equipped). CLOSE (1) - Push the lever forward to close the bowl. Release the lever and it will return to HOLD. HOLD (2) - Release the lever. The bowl will remain in the position it