HOLDER 1042551 - Caterpillar

For specific information on your host machine, refer to the Operation and Maintenance Manual of your host machine.
Installing the Mixing Bucket on the Skid Steer Loader, Compact Track Loader, Multi Terrain Loader, and Compact Wheel Loader
Improper attachment of work tools could result in injury or death.Do not operate this machine until you have positive indication that the coupler pins are fully engaged.To check for engagement:1. Keep the work tool close to the ground.2. While the lift arms are fully lowered, visually inspect the quick coupler to ensure that the coupler pins are fully extended through the corresponding holes of the work tool mounting bracket.
To assemble the equipment on the Skid Steer Loader, Compact Track Loader, Multi Terrain Loader, and Compact Wheel Loader, carry out the following operations:
Make sure that the mixing bucket is properly placed on the ground, in the rest position, away from sources of danger such as ditches, fuel deposits or electrical enclosures.
Slowly approach the machine to the coupling plate of the equipment.
Hook the top of the machine coupling to the top of the coupling plate.
Slowly move the machine forward and at the same time pull the coupling back to fix the bottom of the coupling plate.
Stop the machine and remove the ignition key.
Lock the coupling between the machine and the equipment by means of the locking device. In case of a hydraulic device, use the control in the cabin to engage it; in case of a mechanical device, a second operator must push the two levers to engage the locking devices.
Illustration 1 g06046718Removing the Mixing Bucket from the Skid Steer Loader, Compact Track Loader, Multi Terrain Loader, and Compact Wheel Loader
Disengaging the coupler pins will release the work tool from control of the operator.Serious injury or death may result from disengaging the work tool when it is in an unstable position or carrying a load.Place the work tool in a safe position before disengaging the coupler pins.
Auxiliary hoses for work tools must be disconnected before the Hydraulic Quick Coupler is disengaged.Pulling the work tool with the auxiliary hoses could result in damage to the host machine or the work tool.
Reach the area where you wish to range the equipment and ensure it has a leveled, solid ground.
Operate the machine controls and lower the equipment to the ground in a stable position.
Stop the machine.
Alternatively act on the control lever to relieve any residual pressure from the pipes.
Disconnect the hoses from the quick couplings of the auxiliary circuit of the machine.
Disconnect the electric socket (if any) of the equipment from the plug on the machine.
Park the machine in a stable position (i.e. parking brake, stabilizing feet, etc.); stop the diesel engine and remove the ignition key.
Unlock the equipment by means of the device available on the machine’s coupling.
Start the machine and move slowly in reverse; at the same time, pull out the machine coupling from the coupling plate.