HOLDER 1073343 - Caterpillar

If necessary, remove the oil level switch. Follow Step 5.a through Step 5.c in order to remove oil level switch (10) from the engine oil pan (7).
Cut cable strap (12).
Remove oil level switch (10) from the engine oil pan (7).
Remove O-ring seal (14) from oil level switch (10).
Illustration 3 g02475997
Support the assembly of engine oil pan (7). Remove bolts (14) and bolts (15).
Remove engine oil pan (7) and remove gasket (13). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Studs
M8 by 100 mm 4
B - Loctite 5900 -
C - Loctite 243 -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the wiring harness assembly is correctly routed and the cable straps are not over tightened. Over tightening of the cable straps will damage the wiring harness and the convoluting.
Ensure that the gasket faces of the cylinder block and the engine oil pan are clean and free from damage.
Illustration 4 g02476001
Illustration 5 g02476000
Illustration 6 g02475999
Install Tooling (A) to Positions (X) in the cylinder block.
Apply a bead of Tooling (B) to Positions (Y) on the cylinder block. Note: If the bridge piece for the cylinder block has just been installed, the engine oil pan must be installed before Tooling (B) has cured.
Illustration 7 g02475997
Illustration 8 g02476166
Position a new gasket (13) onto engine oil pan (7).
Align the assembly of the engine oil pan with Tooling (A). Install the assembly of engine oil pan (7) to the cylinder block.
Install bolts (15) finger tight.
Remove Tooling (A).
Install new bolts (14) in Position (Z) hand tight.
Install remaining bolts (14) and the remaining bolts (15).
Tighten bolts (14) and bolts (15) to a torque of 22 N m (16 lb ft). Refer to Specifications, "Engine Oil Pan" for the correct tightening sequence.
Illustration 9 g02475996
Illustration 10 g02476004
Install a new O-ring seal (9) (not shown) to drain plug (8). Install the drain plug to engine oil pan (7). Tighten the oil drain plug to a torque of 34 N m (25 lb ft).
If necessary, follow Step 12.a through Step 12.f in order to install the assembly of the dipstick tube.
Install a new O-ring seal (5) and a new seal (6) to tube assembly (1).
Apply Tooling (C) to nut (4).
Install the tube assembly (1) to engine oil pan (7). Loosely tight nut (4). Note: Ensure that the orientation of the tube assembly is correct.
Install bolt (2) and bolt (3) finger tight.
Tighten nut (4) to a torque of 18 N m (13 lb ft). Install the dipstick.
Tighten bolt (2) and bolt (3) to a torque of 22 N m (195 lb in).
If necessary, install the oil level switch. Follow Step 13.a through Step 13.c in order to install oil level switch (10) to the engine oil pan (7).
Install a new O-ring seal (14) oil level switch (10).
Install oil level switch (10) to engine oil pan (7). Tighten the oil level switch to a torque of 34 N m (301 lb in).
Install a new cable strap (12). Note: Ensure that the cable strap meets the