HOLDER-FUSE 3045284 - Caterpillar

Which Generate This Code:This diagnostic code is associated with the left joystick. It indicates the joystick has detected an internal erroneous condition. The module has detected that the analog value of the joystick is outside of the calibration range when the joystick is fully deflected. The module may also have detected that the center switch is OFF while the minimum analog value is too high. All functions that are associated with the movement of the joystick will be disabled while this diagnostic code is active.The possible causes of this diagnostic code are listed below:
The internal sensors of the joystick are out of calibration.
The internal sensors of the joystick are malfunctioning.Test Step 1. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the "ERROR X-AXIS" code.Expected Result:The "ERROR X-AXIS" code is active.Results:
YES - The "ERROR X-AXIS" code is active.Repair: If the diagnostic code is still active, the module may be faulty.Prior to replacing a module, always contact your dealership's Technical Communicator for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the cause of the diagnostic code is not found, replace the module.STOP