HOLDER-BIT 4K6302 - Caterpillar

Illustration 38 g02220113
(1) Caterpillar World manufacturing code (characters 1-3)
(2) Machine description (characters 4-8)
(3) Check character (character 9)
(4) Machine Indicator Section (MIS) or Product Sequence Number (characters 10-17). These characters were previously referred to as the Serial Number. First Quarter 2001, the Caterpillar Product Identification Number (PIN) changed from 8 characters to 17 characters. The Product ID that is required by the PL522 / PL523 System is the last eight digits. Refer to Item 4 in Illustration 38.Click "OK" after changing each parameter to return to the Configuration screen.To configure a value, highlight the value and select “Change” at the lower left corner of the screen. The current value will appear along with a pull-down menu to select the new value.
Table 17
Parameter Table
Parameter Description Configuration Notes
Machine Serial Number The Machine Serial Number is used by the PL522 / PL523 system for routing and displaying information by machine. For a non-Caterpillar machine, enter the machine serial number. For Caterpillar machines, enter the last eight characters of the new 17 character PIN for this value. Refer to Illustration 38. The maximum length is 17 characters. DO NOT start the serial number with a space. DO NOT abbreviate the serial number. For example, 1AA00123 should not be shortened to 1AA123 DO NOT use uppercase “O” instead of zero “0”. Machine Security (Available in China Only)
Derate - Some machines can have the machine engine derated remotely by the owner of the machine. The action causes the machine to operate much slower than normal. A warning is given before this action occurs on the display with the machine lock icon and "security pending". When engine derate has happened, the machine display shows the machine lock icon and "Security Enabled". The operator should move the machine to a safe location, apply the parking brake, power the machine down, and notify the site supervisor.Disable - Some machines can be prevented from starting remotely by the owner of the machine. When disabling has happened, the machine display shows the machine lock icon and "security enabled". The operator should notify the site supervisor.Tampering - Tampering with the Product Link to disable the machine can also result in engine "derating" or "disabling" of the machine. To avoid "derating" or "disabling", prevent tampering with the Product Link. If machine diagnostics occur due to Product Link, notify your site supervisor immediately to prevent derating or disabling. An example of this situation is an antenna becoming damaged.Note: The appropriate Monitor, Engine, and Product Link software must be flashed to enable this functionality. Not all machines support this function. Contact your Technical Service Representative for more details.
Illustration 39 g02643821
Security access parameters screen
The level of tamper resistance can be changed from the Security Access Parameters screen. Refer to Illustration 39The Tamper Resistance feature works together with the Vision Link commanded Machine Disable and Derate features.Tamper Resistance Level 1:
Remote Disable
Remote DerateTamper Resistance Level 2:
Tamper Resistance Level 1 features
Tamper Derate due to loss of communication between Tornado and Immobilizer libraries (Product Link and Engine ECMs)
Tamper Derate due to