HOOK GP-COUPLER 3175562 - Caterpillar

Attach a chain around the ROPS. Attach Tooling (A) to the chains.
Illustration 4 g00868586
Illustration 5 g00868584
Illustration 6 g00868582
Attach Tooling (A) to torque converter (19) .
Lower torque converter (19) and remove torque converter (19) . The weight of torque converter (19) is approximately 145 kg (320 lb).
Install the O-ring seal (not shown) on the torque converter.
Connect torque converter (19) to the engine. Install bolts (18) .
Illustration 7 g00868580
Connect tube assemblies (16) to cooler (17) .
Illustration 8 g00868578
Connect hose assembly (15) . Install bolt (13) and bracket (14) .
Illustration 9 g00868576
Install hose assembly (12) .
Illustration 10 g00868575
Install hose assemblies (11) .
Illustration 11 g00868574
Install bottom guard (10) . Install bolts (9) .
Illustration 12 g00868573
Connect hose (8) and tighten hose clamp (7) .
Illustration 13 g00868572
Connect harness assembly (6) .
Illustration 14 g00868571
Connect harness assembly (5) .
Illustration 15 g00868570
Install four bolts (4) .
Illustration 16 g00868568
Connect hose assembly (3) to the flywheel housing.
Illustration 17 g00868567
Install bracket (2) and install bolt (1) .
Check the level of the power train oil. Refer to Operation and Maintenance Manual, SEBU7299, "Transmission System Oil Level - Check" for the correct procedure.
Install the floorplate., End By:
Install the drive shaft. Refer to Disassembly and Assembly, "Drive Shaft - Remove and Install".
Install the bottom guards. Refer to Disassembly and AssemblyRENR4261, "Bottom Guard - Install".