HOSE A 0327900 - Caterpillar

Table 1
Required Tools    
Tool     Part Number     Description     Qty    
A     155-3597     Wheel Chock     4    
B     4C-5809     Electric Hydraulic Pump Gp     1    
C     9U-7536     Lift Stand     2    
Illustration 1 g01674955
(1) Receiver (2) Adjusting bolt
Illustration 2 g01670993
(2) Adjusting boltIn order to adjust the bowl,receivers (1) must be adjusted by adjusting bolt (2). In order to adjust the receivers, the following components must be installed to each side of the machine:
The spindle
The service brakes
The wheel
The tire
The rimNote: Check the air pressure in the tires. The tires must have equal pressure and the pressure must be within the correct specifications before the cutting edge is adjusted.
Illustration 3 g01041528
Chock the tractor tires. Chock the tires on the back and the front with Tool (A). Refer to Illustration 3.
Engage the parking brake. Start the engine and run the engine.
Raise the bowl or lower the bowl in order to obtain a clearance of 152 mm (6 inch) between one side of the cutting edge and the ground.
Measure the distance between the opposite side of the cutting edge and the ground. If the distance from the cutting edge to the ground is not equal on both sides, then proceed to Step 5.
Illustration 4 g01041538
Use Tool (B) and Tool (C) to raise the rear of the machine.
Adjust receivers (1) when the weight of the scraper bowl is off of the wheels. Place the weight of the scraper bowl on the wheels. Measure the distance between the cutting edges and the ground. Repeat the procedure until the correct measurement is obtained.