AVSPARE.COM
parts catalog

HOSE AS 0876510 - Caterpillar



0876510 HOSE AS Caterpillar parts 345C, 345C L, 365C L, M325C MH HOSE
Rating:
27
Alternative (cross code) number:
CA0876510
087-6510
0876510
Caterpillar 0876510 HOSE AS

Buy HOSE AS 0876510 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, WHEELED EXCAVATOR,

Compatible equipment models: 0876510:

EXCAVATOR  345C   345C L  
MOBILE HYD POWER UNIT  365C L  
WHEELED EXCAVATOR  M325C MH   Caterpillar
Number on catalog scheme: 61
 
  For full view, you need register

Information:


Illustration 1 g00387727
Schematic of the Detent Coil
This diagnostic code is associated with the Detent Coil. The FMI 05 means that the ECM has determined that the current of the solenoid is below normal. The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0359 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The lift lever will not release from the RAISE detent position. The lift kickout will not function.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire H719-OR(Orange)) to contact 2 (wire H716-WH(White)).
Observe the status of the CID 0359 FMI 05. Expected Result:The CID 0359 FMI 05 remains active. The FMI has not changed and the "05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The active CID 0359 FMI 05 diagnostic code changes to a CID 0359 FMI 06 diagnostic code when the jumper wire is installed. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector, measure the resistance from signal contact J1-18 (wire H719-OR(Orange)) to contact J1-7 (wire H716-WH(White)). Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5.0 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire H719-OR(Orange) or in wire H716-WH(White) of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0359 FMI 05. Expected Result:The CID 0359 FMI 05 is active. Results:
YES - The CID 0359 FMI 05 is active. The diagnostic code has not been corrected. The ECM may

Caterpillar parts catalog:

Caterpillar parts catalog
M325C Material Handler PAN00001-UP (MACHINE) POWERED BY 3126B Engine
365C L Mobile Hydraulic Power Unit GSZ00001-UP (MACHINE) POWERED BY C15 Engine
345C L Excavator SCN00001-UP (MACHINE) POWERED BY C13 Engine
345C & 345C L Mobile Hydraulic Power Units M3E00001-UP (MACHINE) POWERED BY C13 Engine


Parts hose Caterpillar catalog:

2455263 HOSE AS
365C, 365C L, 365C L MH, 385C, 385C L, 385C L MH
3074995 HOSE AS
365C, 365C L, 374D L
2455173 HOSE AS
365C, 365C L, 365C L MH
2455166 HOSE AS
365C, 365C L, 365C L MH
2270302 HOSE AS
365B, 365B II, 365B L, 365C, 365C L, 365C L MH
2181124 HOSE AS
365B, 365B II, 365B L, 365C, 365C L, 365C L MH
2181123 HOSE AS
365B, 365B II, 365B L, 365C, 365C L, 365C L MH
2181122 HOSE AS
365B, 365B II, 365B L, 365C, 365C L, 365C L MH
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.