HOSE AS 1113909 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Aftercooler Core - Clean/Test
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Belt Tightener - Lubricate
Coolant - Change
Coolant Extender (ELC) - Add
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Heat Exchanger - Clean/Test
Heat Exchanger - Inspect
Maintenance Recommendations
Sea Water Strainer - Clean/Inspect
Daily
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Power Factor - Check
Walk-Around Inspection
Every Week
Generator Bearing Temperature - Test/Record
Standby Generator Set Maintenance Recommendations
Stator Winding Temperature - Test
Voltage and Frequency - Check
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every 50 Service Hours or Weekly
Aftercooler Condensate Drain Valve - Inspect/Clean
Engine Cooling System Corrosion Protection System - Inspect
Sea Water Strainer - Clean/Inspect
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Fan Drive Bearing - Lubricate
Every Year
Coolant Sample (Level 2) - Obtain
Varistor - Check
Varistor - Inspect
First 14 400 L (3750 US gal) of Fuel or 250 Service Hours
Engine Crankcase Breather - Clean
Engine Valve Lash -