HOSE 1128130 - Caterpillar

normal operation, monitor the power factor and monitor generator loading.When a generator is installed or reconnected, ensure that the total current in any one phase does not exceed the nameplate rating. Each phase should carry the same load, which allows the generator to work at the rated capacity. If one phase current exceeds the nameplate amperage, an electrical imbalance will occur. An electrical imbalance can result in an electrical overload and an electrical imbalance can result in overheating. The power factor can be referred to as the efficiency of the load, which can be expressed as the ratio of kVA to actual kW. The power factor can be calculated by dividing kW by kVA. Power factor is expressed as a decimal. Power factor is used to mean the portion of current that is supplied to a system that is doing useful work. The portion of the current that is not doing useful work is absorbed in maintaining the magnetic field in motors. This current (reactive load) can be maintained without engine power. Low idle is adjustable between 810 and 1450 RPM with a default value of 1000 RPM.Some generator sets are equipped with Woodward governors and some generator sets are equipped with Cat electronic governors. These generator sets have no low idle stop. On generator sets with mechanical governors and generators that are natural gas, the low idle is set at the factory. Adjustment of the low idle on these machines should only be done by a Cat dealer. Note: Operating the generator set at low idle speed for an extended time will cause some voltage regulators to shut off. The generator set must be completely shut down and the generator set must be restarted. This process will allow the voltage regulator to produce an output again.