AVSPARE.COM
parts catalog

HOSE 1129919 - Caterpillar


1129919 HOSE Caterpillar parts 416C, 426C, 428C, 436C, 438C
Rating:
51
Alternative (cross code) number:
CA1129919
112-9919
1129919
Caterpillar 1129919 HOSE
Weight: 0.90 pounds 0 kg.

Buy HOSE 1129919 Caterpillar genuine, new aftermarket tractor parts with delivery
BACKHOE LOADER,

Compatible equipment models: 1129919:

BACKHOE LOADER  416C   426C   428C   436C   438C   Caterpillar
Number on catalog scheme: 5
  For full view, you need register

Information:


Illustration 1 g01322753
Schematic of the Winch Free Spool Solenoid (12 pin ECM connection)
Illustration 2 g02717412
Schematic of the Winch Free Spool Solenoid (70 pin ECM connection)This diagnostic code is associated with the Winch Spool In Solenoid. The FMI 05 means the ECM has determined that an open exists in the circuit for the solenoid.The possible causes of this diagnostic code are listed below:
The energized circuit of the solenoid is open.
The energized circuit of the solenoid is shorted to ground.
The return circuit of the solenoid is open.
The return circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Note: The following procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected.Ensure that the diagnostic code of CID 2268 FMI 05 is active before performing this procedure.Note: Use a Digital Multimeter for the measurements in this procedure.System Response:A level 1 warning will be generated.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. DO NOT start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire F869-BU) to contact 2 (wire J809-BK).
Observe the status of the CID 2268 FMI 05.Expected Result:The CID 2268 FMI 05 remains active when the jumper wire is installed.Results:
YES - The diagnostic code FMI 05 remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic code changes from FMI 05 to FMI 06.Repair: The solenoid has failed. Replace the solenoid. Verify that the new solenoid corrects the problem. STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous Test Step remains.
At the machine harness connector for the ECM, measure the resistance from the signal contact (wire F870-BU) to the return contact (wire J809-BK). Expected Result:The resistance should be less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in the wire with the resistance measuring greater than 5000 ohms. The open is in either signal wire (F870-BU) or return wire (J809-BK) of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step

Caterpillar parts catalog:

Caterpillar parts catalog
428C Backhoe Loader 8RN00001-04088 (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader Side Shift, Parallel Lift 2CR00001-16211 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side Shift, Single Tilt 1JR00001-01106 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side Shift, Parallel Lift 1TR00001-01283 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 4ZN00001-16043 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 5YN00001-15147 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Parallel Lift 1WR00001-08115 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Parallel Lift 1XR00001-02183 (MACHINE) POWERED BY 3054 Engine
426C Backhoe Loader Center Pivot, Single Tilt 1CR00001-00863 (MACHINE) POWERED BY 3054 Engine
426C Backhoe Loader Center Pivot, Single Tilt 1ER00001-00863 (MACHINE) POWERED BY 3054 Engine
426C Backhoe Loader Center Pivot, Parallel Lift 1MR00001-00955 (MACHINE) POWERED BY 3054 Engine
426C Backhoe Loader Center Pivot, Parallel Lift 1NR00001-00953 (MACHINE) POWERED BY 3054 Engine
436C Backhoe Loader Center Pivot, Single Tilt 1FR00001-01415 (MACHINE) POWERED BY 3054 Engine
436C Backhoe Loader Center Pivot, Single Tilt 9JN00001-00883 (MACHINE) POWERED BY 3054 Engine
436C Backhoe Loader Center Pivot, Parallel Lift 1PR00001-01598 (MACHINE) POWERED BY 3054 Engine
436C Backhoe Loader Center Pivot, Parallel Lift 1RR00001-00997 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 5YN15148-16589 (MACHINE) POWERED BY 3054 Engine
426C Backhoe Loader Center Pivot, Parallel Lift 1MR00956-01179 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 5YN16590-UP (MACHINE) POWERED BY 3054 Engine


Parts hose Caterpillar catalog:

6I0516 HOSE
3054B, 3056, 416B, 416C, 426B, 426C, 428B, 428C, 436C, 438C, CB-434B, CB-434C, CB-544, CB-545, PS-300B
9R9218 HOSE AS
416B, 416C, 424D, 428B, 428C, 428D, 432D, 438B, 438C, 438D, 442D, RM-300
5P1505 HOSE
12M 2, 12M 3, 12M 3 AWD, 140M 2, 140M 3, 140M 3 AWD, 160M 2, 160M 3, 160M 3 AWD, 216B, 216B3, 226B, 226B3, 232B, 2384C, 242B, 247B, 247B3, 2484C, 257B, 2864C, 307B, 311, 3116, 311B, 312, 3126, 312B, 3...
9R0418 HOSE AS
414E, 416B, 416C, 416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 426, 426B, 426C, 428, 428B, 428C, 428D, 430D, 430E, 430F, 436C, 438B, 438C
9R4311 HOSE AS
120G, 12G, 130G, 140G, 416B, 416C, 426, 426C, 428
1007443 HOSE AS
414E, 416B, 416C, 416D, 416E, 420D, 422E, 424D, 426B, 426C, 428, 428B, 428C, 428D, 430D, 436C, 438B, 438C, D8R
1129311 HOSE-TURBOCHARGER
416C, 426C, 428C, 436C, 438C
1460029 HOSE
3054, 416C, 420D, 426C, 428C, 430D, 432D, 436C, 438C, 438D, 442D
1173242 HOSE AS
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 735B, 740B
1173243 HOSE AS
428C, 438C, 725, 730
1204553 HOSE AS
416C, 420D, 426C, 428C, 428D, 428E, 432D, 432E, 436C, 438C, 438D, 442D, 442E, 730, 730C
1403638 HOSE-RADIATOR
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1403637 HOSE-RADIATOR
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1533761 HOSE AS
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1386914 HOSE AS
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1386913 HOSE AS
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1386904 HOSE AS
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1460029 HOSE
3054, 416C, 420D, 426C, 428C, 430D, 432D, 436C, 438C, 438D, 442D
1386903 HOSE-MANIFOLD
416C, 416D, 420D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
1129311 HOSE-TURBOCHARGER
416C, 426C, 428C, 436C, 438C
6V1363 HOSE
216, 228, 247, 414E, 416C, 416D, 416E, 420D, 420E, 422E, 424B, 424B HD, 424D, 426C, 428C, 428D, 428E, 430D, 430E, 432D, 432E, 434E, 436C, 438C, 438D, 442D, 442E, 444E, 446D, 450E, 554, 574, 574B, 621B...
1129920 HOSE-RADIATOR
416C, 426C, 428C, 436C, 438C, 554
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.