HOSE AS 1246388 - Caterpillar

Illustration 1 g06249613
Table 1
Item Qty Part Specification Description
1 35 274-4642 Bolt Use the following procedure to tighten the bolts:
1. Torque the bolts to 875 125 N m (645 92 lb ft) in an alternating sequence that fasten the carrier assembly to the axle housing.
2. Turn each bolt by an additional 120 10 degrees in an alternating sequence.
2 25 283-5692 Bolt Torque to 1000 125 N m (738 92 lb ft).
3 1 1L-7518 Bearing Cone During assembly, lubricate with 1P-0808 Multipurpose Grease.
4 30 6V-3532 Bolt Torque to 520 70 N m (384 52 lb ft).
5 1 426-0531 Bevel Gear Set Assembled backlash is 0.40 0.12 mm (0.016 0.005 inch).
6 1 273-1867 Nut Tighten the four 159-3046 Bolts of the locknut to 28 7 N m (248 62 lb in).
7 1 133-4296 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
8 2 8T-6624 Bolt Torque to 850 100 N m (627 74 lb ft).
9 1 367-9752 Bracket Adjust bracket (9) and shroud (10) to achieve equal clearance between the shroud (10) and gears (5) on all sides.
10 1 242-8677 Gear Shroud As
11 2 125-3300 Bolt Tighten the bolts that fasten the bearing caps to the carrier assembly to 1800 200 N m (1328 148 lb ft)after the gear and the shroud have been properly adjusted.