AVSPARE.COM
parts catalog

HOSE AS. 1400492 - Caterpillar



1400492 HOSE AS. Caterpillar parts HOSE
Rating:
21
Alternative (cross code) number:
CA1400492
140-0492
1400492
Caterpillar 1400492 HOSE AS.

Buy HOSE AS. 1400492 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Torque for the twelve bolts on the cover for the transfer gear ... 95 10 lb. ft.(13.14 1.38 mkg)(1) Torque for the seven bolts in the bearing cage for the intermediate transfer gear ... 95 10 lb. ft.(13.14 1.38 mkg)(2) End play for the bearing of the intermediate gear ... .0055 .0025 in.(0.14 0.06 mm)(3) Amount of free motion (backlash) between the bevel gear and the pinion ... .014 .002 in.(0.36 0.05 mm)(4) Torque for the nine bolts that hold the ring to the housing around the parking brake ... 95 10 lb. ft.(13.14 1.38 mkg) Tooth Contact Adjustment:After the free movement (backlash) and bearing preload adjustments have been made, check the correct area of tooth contact between the bevel gear and bevel pinion.Use shims between the bevel pinion shaft bearing cage and the front cover to align the heel (large) ends of the bevel gear and bevel pinion gear teeth as shown at location (A). This will place the bevel pinion in nearly the correct position in relation to the bevel gear.Put Prussian blue, red lead, or paint in a small amount on bevel gear teeth. Turn the bevel pinion and check the marks made on the bevel gear.With no load, the correct tooth contact setting will be as shown at location (B). The area of contact starts near the toe (small end of tooth) of gear and goes about 30 percent up the length of tooth. With this setting, when load is put on gears, it will be applied over the correct area of teeth.On some gears the area of tooth contact may be extended to 80 percent of the length of the tooth when load is put on gears.If tooth contact area on either side of a tooth is near the heel of a tooth, the location of the bevel pinion shaft must be readjusted. Add or remove shims to relocate the bevel pinion shaft. Readjust the bevel gear free movement (backlash). Produce another tooth contact setting. Several adjustments of both the bevel pinion and bevel gear may be necessary before correct tooth contact setting and backlash is made. Always remember that a change in backlash will also result in a change in tooth contact setting. Therefore, be sure the free movement (backlash) is in correct adjustment before checking tooth contact setting.After correct free movement (backlash) and tooth contact setting is made, remove the extra Prussian blue, red lead, or paint from bevel gear and bevel pinion.


Parts hose Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.