HOSE AS 1482964 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-1854 Retaining Ring Pliers 1
B - Plate
51.0 by 102.0 by 6.0 mm (2.00 by 4.00 by 0.25 inch) 2
C 1P-1857 Retaining Ring Pliers 1
D - Tube
57.0 by 203.0 by 6.0 mm (2.25 by 8.00 by 0.25 inch) 1
E 1P-0510 Driver Gp 1
F 2S-3230 Bearing Lubricant -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00925323
Install O-ring seals (54) on rotor cylinder (53). Install the rotor cylinder in motor housing (3). Orient pin (55) of the rotor cylinder with slot (56) in the motor housing.
Illustration 2 g00925216
Install O-ring seals (52) onto rotor cylinder (53).
Illustration 3 g01142958
Install rear end plate (45) on the shaft of rotor (48).
Install O-ring seal (46) over the shaft of the rotor.
Illustration 4 g01142960
Apply Tooling (F) to bearing (44). Install bearing (44) over the shaft of rotor (48) and into rear end plate (45).
Install rotor clamp nut (42) on the shaft of the rotor. Orient the shoulder of the nut toward the bearing.
Illustration 5 g01142961
Tighten rotor clamp nut (42) in order to obtain a clearance of 0.03 to 0.08 mm (0.001 to 0.003 inch) between the rear end plate (45) and rotor (48). Measure the clearance with a feeler gauge. Tighten hex socket head bolt (43) to secure rotor clamp nut (42). Measure the clearance again.
Illustration 6 g00925356
Install rotor (48) into motor housing (3). Align pin (57) into the slot of the rear end plate.
Illustration 7 g01142988
Thoroughly lubricate vanes (47) with SAE 10W oil and install vanes (47) into the rotor.
Install front end plate (50) onto the rotor. Align small hole (58) of front end plate onto rotor pin (59).
Illustration 8 g00925361
Install washers (51) over the shaft of the rotor onto the front end plate.