HOSE AS 1565509 - Caterpillar

Rear View Camera (If Equipped)
The rear view camera system consists of a camera that is located in the middle of the top of the counterweight and a "VIDEO MODE SETTING" menu on the monitor.Note: The rear view camera system has been set up by the factory or by a Caterpillar dealer in order to provide views which comply with specified guidelines. Consult your Caterpillar dealer before any adjustments are made to the system.For more information refer to Operation and Maintenance Manual, "Monitoring System".Side View Camera (If Equipped)
The side view camera system consists of a camera that is located on the top of the fuel tank and a "VIDEO MODE SETTING" menu on the monitor.Note: The side view camera system has been set up by the factory or by a Cat dealer in order to provide views which comply with specified machine right side view. Consult your Cat dealer before any adjustments are made to the system.For more information refer to Operation and Maintenance Manual, "Monitoring System".Work Area Vision System (WAVS) (If Equipped)
Operation
WAVS is a closed circuit video monitoring system. WAVS consists of a 178 mm (7 inch) LCD display and a camera. The display is mounted in the machine cab.Power is supplied to the system when the operator turns the engine start switch to the ON position. The power On/Off button that is on the display is disabled.The camera lens and the display screen will require periodic cleaning. Cleaning instructions for the camera lens and the display are described in the Maintenance section.Automatic Mode
The single camera system is only available with the automatic mode. The single camera system can be placed in "Standby".Note: If the single camera system can be placed in manual mode, notify service personnel.WAVS will automatically display the camera view which is based on current machine operation and the configuration of WAVS. For example, WAVS may be configured to display a side view from a side-mounted camera.Camera
Illustration 1 g01223051
WAVS camera
The orientation of the camera is set during installation. After installation, there should be no need to make any physical adjustments to any of the cameras under normal operating conditions. WAVS uses a fixed-focused camera that has been installed at the factory, a Caterpillar dealer, or a qualified technician.Display
Keypad
Illustration 2 g01291176
(A) Camera Selection Button (multiple cameras only)
(B) Automatic Brightness
(C) Standby Function
(D) Contrast Button
(E) Brightness Button
(F) Decrease Adjustment Button
(G) Increase Adjustment Button
(H) Power Button (disabled)
(I) Camera Select LED Lights (multiple cameras only)
(J) Button Status LED Lights
(K) Light SensorAdjustment
The following selections for the WAVS display can be changed by the operator.
Table 1
Display Button Operation for single camera system
Operation Procedure Notes
Brightness Adjustment Press button (E) in order to enable the "Brightness Adjustment". Then press either button (F) or (G) in order to adjust the brightness. Press any other display button in order to exit brightness adjustment mode.
Contrast Adjustment Press button (D) in order to enable the Contrast Adjustment. Then press either button (6) or (7) in order to adjust the contrast level. Press any other display button in order to