HOSE-AIR 1591555 - Caterpillar

Illustration 12 g06054358
Press rpm increase switch (21) on the throttle control to place the engine in high idle. The engine speed should increase to 2200 rpm.
Monitor the hydraulic oil temperature on operator display (20). Operate the machine until the oil temperature reaches 43 5.6 °C (110 10 °F).Left Drag Conveyor
Illustration 13 g03875556
Tap Service icon (22).
Illustration 14 g03875561
Tap "Calibrations" (23).
Tap "OK" icon (24).
Illustration 15 g03875562
Tap "Left Conveyor" (25).
Tap "OK" icon (24).
Illustration 16 g03875584
Read on-screen warnings (26). Tap down arrow icon (27) to scroll through the warnings.
Illustration 17 g03875586
After fulfilling the requirements of on-screen warnings (26), tap "OK" icon (24).
Illustration 18 g03875590
Read on-screen notices (28). Tap "OK" icon (24).
Follow the on-screen instructions to complete the calibration of the left drag conveyor.
Press rpm decrease switch (7) for the throttle control once to operate the engine in low idle.
Shut off the engine. Either place machine power switch (8) in the OFF position or press and hold push to start switch (5) for 3 seconds. An LED next to the push to start switch will flash when the engine is in shutdown mode.
If the engine was shut down using push to start switch (5), move machine power switch (8) to the OFF position.
Calibrate the right drag conveyor. Refer to "Calibration Procedure" "Right Drag Conveyor".Right Drag Conveyor
Illustration 19 g03875556
Tap Service icon (22).
Illustration 20 g03875561
Tap "Calibrations" (23).
Tap "OK" icon (24).
Illustration 21 g03875596
Tap "Right Conveyor" (29).
Tap "OK" icon (24).
Illustration 22 g03875603
Read on-screen warnings (30). Tap down arrow icon (27) to scroll through the warnings.
Illustration 23 g03875606
After fulfilling the requirements of on-screen warnings (30), tap "OK" icon (24).
Illustration 24 g03875613
Read on-screen notices (31). Tap "OK" icon (24).
Follow the on-screen instructions to complete the calibration of the right drag conveyor.
Press rpm decrease switch (7) for the throttle control once to operate the engine in low idle.
Shut off the engine. Either place machine power switch (8) in the OFF position or press and hold push to start switch (5) for 3 seconds. An LED next to the push to start switch will flash when the engine is in shutdown mode.
If the engine was shut down using push to start switch (5), move machine power switch (8) to the OFF position.
Position cover (15) and secure with three bolts (14) and washers.
Secure prop rod (13) in the stored position.
Close left access panel (12) .
Secure prop rod (11) in the stored position.
Close right access panel (10) and secure latch (9).