HOSE AS 1596128 - Caterpillar

Illustration 2 g02436556Manufacturer Name and Address ____________________Model number (A)____________________Product Identification Number (B)____________________Service Information Plate (C)____________________Year of Manufacture (If Required) (D)____________________CE Plate (If Required) (E)____________________Country of Origin Info Plate (If Required) (F)____________________Electromagnetic Emissions
Note: This label is on machines that are going into Canada.
Illustration 3 g06063443If equipped, this label will be found next to the PIN plate. This label verifies that the product meets the requirements of Canada's ICES-002.Engine Serial Number
This label is located on the engine.Engine Serial Number ____________________Bucket Serial Number
This label is located on the bucket.Bucket Serial Number ____________________Grapple Serial Number
This label is located on the grapple.Bucket Serial Number ____________________Certification
ROPS/FOPS Structure
These messages are positioned on a pillar in the cab.
Illustration 4 g01211895
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification film. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification film.Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information.European Union
Illustration 5 g02010841This plate is positioned on the bottom left side of plate (1) for the PIN.Note: The CE plate is on machines that are certified to the European Union requirements that were effective at that time.For machines compliant to 2006/42/EC, the following information is stamped onto the CE plate. For quick reference, record this information in the spaces that are provided below.
Engine Power Primary Engine (kW)____________________
Engine Power for Additional Engine (If Equipped) ____________________
Typical Machine Operating Weight for European Market (kg)____________________
Year of Construction____________________
Machine Type ____________________Product Link
If equipped, this message is used to verify the certification of the Product Link as an RF transmitter. The following specifications are provided to aid in ensuring compliance with all local regulations:
Table 1
Operating frequency range 148 to 150 MHz
Transmitter power 5-10 w
Illustration 6 g01222547
This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site for satellite-based systems and within 3 m (10 ft) of a blast site for cellular based systems, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than 12 m (40 ft) from the blast perimeter.
This message is located on the control group for the Product Link.If the machine is required to work within 12 m (40 ft) of a blast area, power to the Product Link module must be disconnected.Consult your Cat dealer with any questions that concern the operation of the Product Link in a specific country.Sound Certification
If equipped, this label is located on the cab door.
Illustration 7 g01447432
Certification Label on M314F
Illustration 8 g02242113
Certification Label