1761648 HOSE Caterpillar parts
315C, 318B, D3G, D4G, D5G
Rating:
Alternative (cross code) number:
CA1761648
176-1648
1761648
CA1761648
176-1648
1761648
Weight: 1 pounds 0 kg.
EXCAVATOR, TRACK-TYPE TRACTOR,
Compatible equipment models: 1761648:
Number on catalog scheme:
18
For full view, you need register
Information:
Illustration 1 g03392878
Schematic of the ripper shank raise solenoid
This diagnostic code is associated with the ripper shank lower solenoid. The FMI 05 means that the ECM has determined that an open in the circuit exists.The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. An ECM failure is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0889 - FMI 05 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.Test Step 1. Check the solenoid
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact "1" (wire J921-PK(Pink)) to contact "2" wire H802-GY(Grey).
Observe the status of the diagnostic code.Expected Result:The diagnostic code remains active. Then, the diagnostic code changes from FMI 05 to FMI 06 after the jumper wire is installed.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The solenoid has failed.Repair: The solenoid has failed. Replace the solenoid. Verify that the new solenoid corrects the problem.STOPTest Step 2. Check the harness for an open
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the ECM.
The jumper wire that was installed in the previous test remains in place.
At the machine harness connector, measure the resistance from signal contact J1-58 wire J921-PK(Pink)to contact J1-60 wire H802-GY(Grey).Expected Result:The resistance is less than 5 ohms.Results:
YES - The resistance is less than 5 ohms. The machine harness is correct. Proceed to Test Step 3.
NO - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire (J921-PK(Pink)) or in wire (H802-GY(Grey)) of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 3. Check the operation of the ecmThe disconnect switch and the key start switch remain in the OFF position. The machine harness connector for the solenoid and the ECM connectors remain disconnected.
Remove the jumper wire that was installed in the last test step.
At the J1 connector for the ECM, use a wire removal tool to remove wire J921-PK(Pink)from contact J1-58.
Reconnect the machine harness connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Use a multimeter probe to make a connection with the ECM at contact J1-58 through the empty space in the J1 connector.
Observe the status of the diagnostic code. Ground the other end of the multimeter probe to frame ground.Expected Result:The FMI 05 changes to an FMI 06 when
Caterpillar parts catalog:
Parts hose Caterpillar catalog:
120G, 215, 215B, 215D, 225, 229, 229D, 235, 235C, 235D, 245, 245B, 307, 307B, 312, 312B L, 312C, 315, 315B L, 315C, 317, 317B LN, 318B, 318C, 320 L, 3208, 320B, 322, 322 LN, 325, 330 FM L, 330 L, 3412...
1090, 1190, 1190T, 120G, 1290T, 1390, 140G, 215, 215B, 215C, 215D, 225, 225D, 227, 229, 2290, 229D, 231D, 235, 235B, 235C, 235D, 236D, 2384C, 2390, 2391, 242D, 245, 245B, 245D, 246D, 2470C, 2484C, 249...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 14...
314C, 315, 315C, 317, 318C, 385B, 928G, 928HZ, IT28G
315B, 315B L, 315C, 315D L, 316E L, 317B LN, 318D L, 318D2 L, 318E L, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 32...
315, 315B, 315C, 317B LN, 318B, 933C, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
307B, 307C, 308C, 311D LRR, 311F LRR, 312C L, 314C, 314D CR, 314D LCR, 315C, 315D L, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D...
307C, 311C, 311D LRR, 311F LRR, 312C, 312C L, 312D, 312D L, 312E, 312E L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 316E L, 318C, 318E L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 32...
307C, 308C, 315C, 315D L, 319D L, 320B, 320C, 320C FM, 320C L, 320D, 320D L, 320D LRR, 320D RR, 320E LRR, 321D LCR, 322, 322 FM L, 322B, 322B L, 322C, 322C FM, 323D L, 324D FM, 325, 325 L, 325 LN, 325...
307C, 308C, 311C, 311D LRR, 311F LRR, 312C, 312D, 312D L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 319D L, 319D LN, 320 L, 320B, 320C, 320D, 320D FM, 320D FM RR, 320D L, 320D LN, 320D...
308C, 312C, 312C L, 312D, 312D L, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320D, 320D FM, 320D GC, 320D L, 320D LRR, 320D RR, 320D2...
315C, 318C, 319C, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D2, 320D2 GC, 320D2 L, 322C, 322C FM, 323D L, 323D LN, 323D2 L, 325C, 325C FM, 325C L, 350, 385B
1626349
HOSE-AIR
318B
318B
1355628
HOSE-AIR
315B, 317B LN, 318B
315B, 317B LN, 318B
1731220
HOSE-LOWER
317B LN, 318B
317B LN, 318B
1731219
HOSE-UPPER
317B LN, 318B
317B LN, 318B
315, 315B, 315C, 317B LN, 318B, D3C III, D3G, D4C III, D4G, D5C III, D5G
315, 315B, 315C, 317B LN, 318B, 933C, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
1732303
HOSE AS
318B
318B
1348413
HOSE AS
318B, 318C, 319C
318B, 318C, 319C
1525637
HOSE AS
318B
318B
1351251
HOSE AS
311B, 312B, 312C, 317B LN, 318B
311B, 312B, 312C, 317B LN, 318B
1176431
HOSE
315, 315B, 315C, 317B LN, 318B
315, 315B, 315C, 317B LN, 318B
0949034
HOSE AS
308C, 315B, 315C, 317B LN, 318B, 320 L, 320B, 320B L, 320N, 933, 933C, 939, 939C, D3C III, D4C III, D5C III, E110B, E120B
308C, 315B, 315C, 317B LN, 318B, 320 L, 320B, 320B L, 320N, 933, 933C, 939, 939C, D3C III, D4C III, D5C III, E110B, E120B