HOSE AS 1797452 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-0006 Governor Pliers 1 Start By:
Remove the rear cover from the cab. Refer to Disassembly and Assembly, "Cover (Cab Rear) - Remove and Install".
The space between the body and the frame becomes a zero clearance area when the body is lowered. Failure to install the retaining cable can result in injury or death to personnel working in this area.
Illustration 1 g00560270
Use Tooling (A) to disconnect harness assembly (1) from payload electronic control module (2).
Illustration 2 g00560271
Remove bolts (3) that secure payload electronic control module (2) to the mounting plate. Remove payload electronic control module (2) from the cab. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 6V-0006 Governor Pliers 1
Verify that all of the components of the payload electronic control module are clean and free of foreign material prior to installation.
Inspect all of the components for wear or for damage and replace the components, if necessary.
Illustration 3 g00560271
Position payload electronic control module (2) on the mounting plate. Install bolts (3) that secure payload electronic control module (2) to the mounting plate.
Illustration 4 g00560270
Use Tooling (A) to connect harness assembly (1) to payload electronic control module (2). End By:
Install the rear cover to the cab. Refer to Disassembly and Assembly, "Cover (Cab Rear) - Remove and Install".