HOSE-RADIATOR 1857831 - Caterpillar

Move the No. 1 piston to the top center position on the compression stroke. Remove the timing bolt.Note: Refer to Testing and Adjusting Manual, "Finding Top Center Position for No. 1 Piston".
Rotate the crankcase counterclockwise by 30 degrees.
Illustration 5 g01109631
Timing Pin Cover (14) Timing pin cover (15) Cover for timing gear (16) Nut
Remove timing pin cover (14) from the side of the fuel injection pump housing.
Illustration 6 g01109632
Installed Fuel Pump Timing Pin (17) 6V-4186 Fuel Pump Timing Pin
Install 6V-4186 Fuel Pump Timing Pin (17) in the fuel injection pump housing. See Illustration 6.
Slowly rotate the crankshaft counterclockwise until fuel pump timing pin (17) fits into the slot inside the fuel pump camshaft.
Too much pressure on the timing pin can damage the fuel injection pump camshaft or the timing pin.
Place the timing bolt into the timing hole in the flywheel housing.
Slowly move the crankshaft counterclockwise until the fuel pump camshaft fits tightly against the timing pin. View the engine from the flywheel end during this procedure. This removes the gear clearance from the drive train.
If the timing bolt can be installed in the flywheel and the timing pin can be installed in the fuel pump camshaft, the timing is correct.
If either the timing bolt or the timing pin can NOT be installed, follow Steps 10 through 18.
Remove nuts (16) and timing pin cover (15) from the timing gear housing.
Illustration 7 g01109634
Timing Gear for Fuel Injection Pump (18) Bolt
Loosen bolt (18) that connects the timing gear to the fuel pump camshaft. Turn bolt (18) counterclockwise for three turns.
Install the 8S-2264 Puller Gp and loosen the timing gear from the fuel pump camshaft.
Illustration 8 g01109640
Installed Puller Tools (19) 8S-2264 Puller Gp (20) 8B-7560 Step Plate (21) 1B-3680 Bolt (22) 4B-5271 Washer
Rotate the flywheel clockwise to 60 degrees before No. 1 piston reaches the top center position.
Tighten bolt (18) finger tight. Ensure that fuel pump timing pin (17) fits inside the groove in the fuel pump camshaft.
Slowly rotate the crankshaft counterclockwise until the timing bolt can be installed in the flywheel.
Illustration 9 g01109651
Installed Adapter on the Timing Gear (23) 4C-9874 Spanner Wrench
Install 4C-9874 Spanner Wrench (23) onto the timing gear.
Maintain a torque of 68 N m (50 lb ft) on spanner wrench (23) in a clockwise direction, and tighten bolt (18) that retains the timing gear to 270 25 N m (200 20 lb ft).
Remove the timing bolt from the flywheel and remove fuel pump timing pin (17) from the fuel pump camshaft.
Rotate the crankshaft counterclockwise for two revolutions.
If the timing bolt can be installed in the flywheel and the timing pin can be installed in the fuel pump camshaft, the timing is correct.
If either the timing bolt or the timing pin can NOT be installed, repeat Steps 10 through 17.b.
Use the 8T-5300 Engine Timing Indicator Group to verify the change to the engine's timing.