HOSE AS 1963888 - Caterpillar

Illustration 1 g03409002
(9) Connects to the harness connector tag "Autolube Level Switch" (10) Connects to the harness connector tag "Mates to Autolube LVL SW" (11) Connects to Autolube Pump Level Sensor (A) Two wires 302 mm (11.9 inch) (B) Four wires 200 mm (7.9 inch) (C) Two wires 283 mm (11.1 inch)
Table 2
Connector (9) a 102-8804 Receptacle Kit (2)    
Color-Gauge     Position     Term/Plug    
    1     8T-8737 (5)    
    2     8T-8737 (5)    
Black-16     3     9X-3401 (4)    
Black-16     4     9X-3401 (4)    
Table 3
Connector (10) a 102-8804 Receptacle Kit (2)    
Color-Gauge     Position     Term/Plug    
Black-16     1     9X-3401 (4)    
Black-16     2     9X-3401 (4)    
    3     8T-8737 (5)    
    4     8T-8737 (5)    
Table 4
Connector (11) a 155-2271 Connecting Plug Kit (1)    
Color-Gauge     Position     Term/Plug    
Black-16     1     9X-3402 (3)    
Black-16     2     9X-3402 (3)    
Black-16     3     9X-3402 (3)    
Black-16     4     9X-3402 (3)    
Cut four wires for the harness assembly. Cut two wires to a length of 502 mm (19.8 inch). Cut two wires to a length of 483 mm (19.0 inch). Use the parts listed in Table 1 to fabricate the harness assembly. Refer to all four tables and the Illustration 1. Use six cable straps (7) to bundle the wires together between the connectors.
Illustration 2 g03409343
Disconnect the 360-2947 Wiring Harness connection (13) that is labeled "Autolube Level Switch" for the autolube pump level sensor. The end of the 360-2947 Wiring Harness will be disconnected until later in the procedure. Install harness assembly connector (11) to the connector for the autolube pump level sensor that is on the pump unit.
Illustration 3 g03409344
Remove receptacle assembly (14) that covers the connection on the 314-9556 Chassis Harness As connector that is labeled "Mates to Autolube LVL SW". Discard the receptacle assembly. Install harness assembly connector (10) to the 314-9556 Chassis Harness As connector that is labeled "Mates to Autolube LVL SW".
Install harness assembly connector (9) to the disconnected end of the 360-2947 Wiring Harness connector that is labeled "Autolube Level Switch". This connector was disconnected in Step 2. Refer to Step 2, and Illustration 2.
Use the six cable straps (8) to secure the harness assembly to the 360-2947 Wiring Harness .