HOSE AS 1978872 - Caterpillar

Illustration 1 g06180324
(1) Stick Out
(2) Swing Right
(3) Stick In
(4) Swing Left
(5) Boom Lower
(6) Tool Open
(7) Boom Raise
(8) Tool Close
(9) HOLD
The Fine Swing Control delays the engagement of the swing parking brake.If the machine is operating on a slope with the Fine Swing Control in the ON position, the swing motion may become uncontrollable which could result in property damage, personal injury or death.Turn the Fine Swing Control to the OFF position when the machine is operating on a slope.
When you release the joysticks from any position, the joysticks will return to HOLD position (9). Movement of the upper structure will stop unless the fine swing control (if equipped) is ON. When the fine swing control is ON, the swing parking brake will not activate until 6.5 seconds after the joystick control for the swing function returns to the HOLD position.The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left joystick and the pattern on the right pertains to the right joystick.The machine control pattern can be varied. Refer to Operation and Maintenance Manual, "Joystick Controls Alternate Patterns" for more information.Two functions may be performed at the same time by moving a joystick diagonally.Rotating Tool Control
Illustration 2 g06260903
(A) Left joystick
(B) Right joystick
(1) Thumb wheel (Clockwise)
(2) Thumb wheel (Counterclockwise)
(3) Horn switch
(4) AEC switch
The joystick and controls on the joystick can be configured with different functions. Always make sure to check the joystick configuration on the monitor before using the machine to avoid unexpected machine movement. These unexpected machine movements could cause a hazard resulting in serious injury or death.
(1) Rotate Clockwise - Move the thumb wheel upward to rotate the work tool clockwise.
(2) Rotate Counterclockwise - Move the thumb wheel downward to rotate the work tool counterclockwise.
(3) Horn - Press the horn switch on the left joystick to activate the horn.
(4) AEC Switch - Press the AEC switch on the right joystick to activate low engine speed. Press the switch again to activate high engine speed.