HOSE ASSEM. (19.75" LONG) 1S0889 - Caterpillar

Installation Procedure
Illustration 1 g00824815
Install heater coil (23) in the original position.
Install new seals (25). Install bolts (26) on both ends of the heater coil.
Connect hoses (24) on the heater coil and tighten the hose clamps. Tighten the hose clamps to a torque of 4.5 0.5 N m (40 4 lb in).
Illustration 2 g00824814
Install capillary tube (22) in evaporator coil (21) between the second row and the third row. Insert the capillary tube to a depth of 230 10 mm (9.1 0.4 inch).
Illustration 3 g00824812
Install gaskets (20) .
Illustration 4 g01023090
Open two valves (19) .
Illustration 5 g00824593
Position cover (16) and install bolts (17) and bolts (18) .
Illustration 6 g00824590
Position cable (14) on the valve and install clip (15) .
Install the retainer and screw (13) .
Illustration 7 g00824588
Install alarm (11) and bolt (12). Connect harness assembly (10) .
Illustration 8 g00824587
Install air filter (9) and access panel (8) .
Illustration 9 g00824586
Install rubber storage compartment (7) .
Illustration 10 g00824584
Install cover (5) and bolts (6) .
Install the insulation and the floormat on the cab floor.
Illustration 11 g00824583
Install storage compartment (3) and screws (4) .
Illustration 12 g00824581
Install storage compartment (2) and screws (1) .End By: Install the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".