AVSPARE.COM
parts catalog

HOSE-RADIATOR 2040899 - Caterpillar


2040899 HOSE-RADIATOR Caterpillar parts 318C, 319C
Rating:
72
Alternative (cross code) number:
CA2040899
204-0899
2040899
Caterpillar 2040899 HOSE-RADIATOR
Weight: 3 pounds 1 kg.

Buy HOSE-RADIATOR 2040899 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
$22.89
 

04 Jun 2022

HK: sag Kong Nadi T
S Husky Cute Fox Welcome Door Mat Animal Fallen Leaves Autumn Rug for Kitchen Bathroom Outdoor Porch Laundry Living Room Washable Carpet 36 x 24 in 2040899
S Husky Size: 36 x 24 inches (91 x 61 cm). || Senior Material: Polyester, sponge, non-woven fabric which are absorbent, soft, wear-resistant and delicate high density memory foam. || Large Outdoor Indoor Door Mat | Non-Slip Duty Front Welcome Doormat Rug, Outside Patio, Inside Entry Way, Catches Dirt Dust Snow & Mud. || Ideal Gifts: Not only decoring your home when holiday or themed party,also as a perfect festival/housewarming presents. || Gentle hand wash separately in cold water.
$10.99
 

07 Feb 2021
6.0 ounces
-: -
DZGlobal Fox Fallen Leaves Doormat Watercolor Cute Animal Pattern Welcome Doormat Non-Slip Carpet Outdoor Front Rug for Entry 31 X 20 in 2040899 16" X 24"
Our doormat MATERIAL: Its made of 100% pure flannel , which is one of the strongest natural fibers in the world that can’t splits .The material easily captures moisture, dirt, and other particles.Hard-wearing skidproof rubber backing that stays in place for safe and slip-free stepping and scraping. || Door Mats Size: (16inchx24inch, 18inchx30inch, 20inchx32 inch, thickness: 0.39 inch) The doormat is cuts by hand and maybe one or two inches error || Applicable places: Contemporary, fancy, door mat & kitchen rug designs for Indoor/Outdoor usage; kitchen, bathroom, bedroom, living room, door entrances, patio entry ways || The attractive and antique design: ANTI-SLIP WOVEN PATTERN- Rubber back sticks the mat to the floor and giving it cushion and non-slippery quality.The pattern on this product is woven instead of printed. Ensure that the pattern lasts for a long time without fading. || Easy to clean : Door mats inherently stain, fade and wear-resistant for fuss-free maintenance. Easy to clean with minimal efforts.Just wash by hand or gently machine wash ,plus neutral detergent, do not use bleach .
$16.90
 

04 Jun 2022

HK: sag Kong Nadi T
S Husky Fox Fallen Leaves Doormat Watercolor Cute Animal Pattern Welcome Doormat Non-Slip Carpet Outdoor Front Rug for Entry 31 x 20 in 2040899
S Husky Size: 31 x 20 inches (79 x 51 cm). || Senior Material: Polyester, sponge, non-woven fabric which are absorbent, soft, wear-resistant and delicate high density memory foam. || Multi-function: warm house / holiday party gift, holiday decoration, entrance channel, door, office, garden, outdoor, bath mat. || Ideal Gifts: Not only decoring your home when holiday or themed party,also as a perfect festival/housewarming presents. || Gentle hand wash separately in cold water.
Number on catalog scheme: 6
  For full view, you need register

Compatible equipment models: 2040899:

EXCAVATOR  318C   319C   Caterpillar

Information:


Illustration 1 g01269197
Blade Sideshift Left Solenoid connections
This diagnostic code is associated with the blade sideshift left solenoid. The FMI 03 means that the Implement ECM has determined that the voltage of the solenoid circuit is above normal.The Implement ECM provides a PWM output signal to the solenoid in order to provide proportional control of the solenoid. The ECM will vary the electrical current of the PWM output signal based on the input command that is received from the blade sideshift position sensor that is located in the right joystick assembly.Conditions that can cause this diagnostic code are listed:
The energize circuit of the solenoid is shorted to another voltage source.
The ECM has failed. This is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the solenoid. Disconnect the machine harness connectors J1 and J2 from the ECM.
At the machine harness ECM connector J1, measure the resistance from contact J1-65 (wire U750-PK(Pink)) to all J1 and J2 contacts that are used on the ECM connectors. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between wire U750-PK(Pink) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE ECMThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the solenoid and the ECM remain disconnected.
At the machine harness connector J1 for the ECM, use a 151-6320 Removal Tool to remove the solenoid energize wire U750-PK(Pink) and socket at contact J1-65 from the harness connector.
Reconnect the machine harness J1 and J2 connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID 2165 FMI 03 diagnostic code. Expected Result:The CID 2165 FMI 03 diagnostic code is no longer active. A CID 2165

Caterpillar parts catalog:

Caterpillar parts catalog
318C L & 318C LN Excavators GPA00001-UP (MACHINE) POWERED BY 3066 Engine
318C Excavators BTG00001-UP (MACHINE) POWERED BY 3066 Engine
319C LN Hydraulic Excavator KGL00001-UP (MACHINE) POWERED BY 3066 Engine


Parts hose Caterpillar catalog:

5P0743 HOSE
120K, 120K 2, 120M, 12K, 12M, 140G, 140K, 140K 2, 140M, 160K, 160M, 16M, 216, 228, 236, 236B, 236D, 242B, 242D, 246D, 247, 247B, 248, 257D, 259D, 262D, 267, 267B, 268B, 272D, 272D XHP, 277D, 279D, 287...
7Y1976 HOSE-WATER
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304, 304.5, 304C CR, 304D CR, 304E, 305, 305.5, 305.5D, 305.5E, 305C CR, 305D CR, 30...
4I3823 HOSE AS
315, 315B L, 317, 317B LN, 318C, 319C, 320 L, 320B, 320B L, 320B U, 320C, 320N, 321B, 321C, 322, 322 FM L, 322 LN, 322B, 322B L, 322B LN, 322C, 328D LCR, 330, 330 FM L, 330 L
4I3991 HOSE AS
307C, 311F LRR, 312C, 312C L, 312D, 312E, 312E L, 314D CR, 314D LCR, 315D L, 318C, 319C, 319D L, 319D LN, 320 L, 320B, 320C, 320D, 320D FM RR, 320D2 L, 321C, 322B, 322B L, 322B LN, 322C, 322C FM, 325,...
4I3994 HOSE AS
307C, 311C, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 320 L, 320B, 320C, 320D, 320D FM, 320D GC, 320D L, 32...
1849283 HOSE AS
312C, 312C L, 315C, 318C, 320C, 320C FM, 320C L, 322C, 322C FM, 325C, 325C FM, 325C L, 330C, 330C FM, 330C L, 330C MH
1116752 HOSE AS
308C, 312C, 312C L, 312D, 312D L, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320D, 320D FM, 320D GC, 320D L, 320D LRR, 320D RR, 320D2...
4I0812 HOSE AS
308C, 311C, 311D LRR, 311F LRR, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 318C, 319C, 320C, 320D, 320E L, 320E LN, 321C, 321D LCR, 322C, 322C FM, 323E L, 325 L, 325B, 325C, 325C FM, 325D L, 33...
1875954 HOSE AS
316E L, 318C, 318E L, 319C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D2, 320D2 GC, 320D2 L, 322C, 322C FM, 323D L, 323D LN, 323D2 L, 324D FM, 324D FM LL, 325C FM, 325D FM, 325D FM LL
4I8799 HOSE AS
318C, 319C, 320B, 320C, 320D FM RR, 320D L, 320D LN, 320D LRR, 320D RR, 320E LRR, 320E RR, 321C, 322B LN, 322C, 323D L, 323D LN, 323D SA, 324D, 324D FM, 324D L, 325B L, 325C, 325D, 325D L, 328D LCR, 3...
7T0630 HOSE AS
318C, 319C, D8L, D9N
9C2633 HOSE AS
318C, 319C, 320B, 320C, 325B L, 330B L, 966D, 966F, 966F II, 970F
5I7699 HOSE
318C, 319C, 320 L, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321B, 321C, 323D L, 323D LN
1968228 HOSE
318C, 319C, 320C, 321C, 323D L, 323D LN
2331165 HOSE
318C, 319C, 320C
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.