HOSE-AIR INLET 2091542 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Lower the bucket to the ground.
Engage the parking brake.
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release" for the machine that is being serviced.
Illustration 1 g00877139
Disconnect electrical connector (1) .
Remove two bolts (2) and the washers.
Remove pressure sensor (3) for the payload monitor.
Illustration 2 g00877191
Disconnect electrical connector (4) .
Remove bolt (5) and the clip.
Illustration 3 g00877197
Remove three tube assemblies (6) from the top of ride control valve (7) .
Disconnect two hose assemblies (8) from the bottom of ride control valve (7) .
Illustration 4 g00877205
Remove eight bolts (9) and the washers.
Remove ride control valve (7) .