HOSE 2106641 - Caterpillar

Procedure to Install the 169-6326 Radio (Deluxe CD Player)
On the back of the radio, install the 136-5490 Bushing onto the stud.
Install the 102-0382 Sleeve into the headliner. If necessary, slightly squeeze the sleeve at the top and the bottom. After you position the sleeve, make sure that you adjust the top and the bottom for a tight fit.
After you install the sleeve, bend back the tabs. This will secure the sleeve in the headliner.Note: There are many tabs on the sleeve. These tabs are for panels with different thicknesses. Use the tabs that provide the most secure mounting.
Locate the radio harness assembly and the coaxial cable. Pull the radio harness assembly and the coaxial cable out of the headliner so that the radio harness assembly and the coaxial cable are accessible.
Locate the angled plate in the mounting plate.
While you hold the radio, connect the 155-0044 Harness to the radio. The 155-0044 Harness is then connected to the radio harness assembly. Also, connect the cable for the radio antenna to the coaxial cable in the headliner.Note: If you are installing the optional CD player, place the 136-5447 Harness into the headliner. Connect the 136-5447 Harness to the radio. Connect the 136-5447 Harness to the 170-7251 Compact Disc Changer . See ""Procedure to Install the 170-7251 Compact Disc Changer "" in this Special Instruction for further instructions.
Install the radio into the sleeve. The radio should snap into the sleeve. If you use moderate force and the radio does not snap into the sleeve, remove the sleeve. Install the sleeve so that the sleeve is positioned slightly out of the opening. Install the radio and the sleeve.
Use the recommended removal tools in order to remove the radio. Fully insert the removal tools into the holes on each side of the radio. Then, the removal tools will release the radio from the sleeve. After the radio is released from the sleeve, pull on the removal tools in order to remove the radio.Note: The removal tools are provided with the radio.Procedure to Install the 170-7251 Compact Disc Changer on Tillage Tractors Only
The 170-7251 Compact Disc Changer requires the following items for installation:
One 170-7251 Compact Disc Changer
One 136-5457 Bracket
One 136-5447 Harness
Six 5I-3166 Screws
Four 136-5634 Screws Note: The 170-7251 Compact Disc Changer is also a CD player. The terms may be used interchangeably.Note: In order to install the CD changer, only use the 136-5457 Bracket . Do not use the bracket that is provided with the CD changer. In order to use the 170-7251 Compact Disc Changer , you must install either the 169-6325 Radio or the 169-6326 Radio .For information about the operation of the CD player, see the manual that is supplied with the CD player.
Install either the 169-6325 Radio or the 169-6326 Radio . Make sure that you install the 136-5447 Harness to the radio. Route the other end of the 136-5447 Harness to the left side