HOSE AS 2128606 - Caterpillar

Table 1
Needed Parts    
Item    Qty    Part Number    Description    
1     1     214-2456     Regulator    
2     6     220-0250     Screw    
3     1     215-3634     Glass    
4     1     3S-2093     Cable Strap    
Remove the existing regulator. Refer to the appropriate Disassembly and Assembly for the proper procedure.
Illustration 1 g00921435
Drill two holes (D) in 162-4035 Plate As. The holes should have a diameter of 7 mm (0.28 inch). See Illustration 1 and Table 2.Note: 162-4035 Plate As was removed from the top of the door assembly.
Table 2
Item     Dimension    
A    
83 mm (3.3 inch)    
B    
17 mm (0.7 inch)    
C    
55 mm (2.2 inch)    
Connect the wire harness to 214-2456 Regulator (1) (not shown).
Illustration 2 g00922957
Use five 220-0250 Screws (2) to install 214-2456 Regulator (1) to the door.
Install 215-3634 Glass (3) (not shown) into the slots on the regulator arm.
Use the existing hardware to install the modified 162-4035 Plate As .
Illustration 3 g00922967
Use one 220-0250 Screws (2) to fasten the regulator arm to the plate assembly.
Illustration 4 g00922983
Move the glass to the halfway point. Tighten the left hand screw on the regulator to a torque of 6.8 N m (60 lb in).
Raise the glass to the up position. Tighten the six 220-0250 Screws (2) to a torque of 12 N m (106 lb in).
Lower the glass to the halfway position. Tighten the four bolts that hold the plate. Tighten the bolts to a torque of 28 N m (21 lb ft).
Illustration 5 g00922986
Tighten the right hand screw on the regulator to a torque of 6.8 N m (60 lb in).
Illustration 6 g00922991
Use 3S-2093 Cable Strap (4) to fasten the cable track to the plate. Trim the cable strap, if necessary.
Reinstall the door panel. Refer to the appropriate Disassembly and Assembly for the proper procedure.