HOSE AS 2152693 - Caterpillar

Table 1
Service Tools    
Part Number    Description    
(1)     Caterpillar Electronic Technician (ET) Software    
6V-7070
9U-7330     Digital Multimeter    
8T-3224     Needle Tip Group    
7X-1710     Multimeter Probe Group    
8T-8726     Cable Assembly (3-Pin)    
6V-3000     Connector Repair Kit (Sure Seal)    
9U-7246     Connector Repair Kit (Deutsch DT Type)    
4C-3406     Connector Repair Kit (Deutsch)    
4C-8195     Control Service Tool (Switch Box)    
( 1 ) To use the CAT ET, order Special Publication, JERD2124, "ET Single Use Program License", Special Publication, JEHP1026, "Information and Requirements Sheet", and Special Publication, JERD2142, "Data Subscription". The Special Publication, JEHP1026, "Information and Requirements Sheet" lists the required hardware and the features of CAT ET.Reference: For more information on the Caterpillar Monitoring System, refer to the Service Manual module Testing and Adjusting, "Using Caterpillar Monitoring System to Determine Diagnostic Codes".Reference: For more information on the Caterpillar Electronic Technician (ET), refer to the Service Manual module Testing and Adjusting, "Using Caterpillar Electronic Technician to Determine Service Codes".Use the digital multimeter for making continuity checks or for measuring voltage. For instructions about the use of the 6V-7070 Digital Multimeter, refer to Special Instruction, SEHS7734. The 7X-1710 Multimeter Probe Group is used in order to measure the voltage at the connectors without needing to disconnect the connectors. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a three pin breakout. The adapter cable is used for measurements in the sensor circuits.Note: Except for harness tests, using continuity testers such as the 8T-0500 Continuity Tester or voltage testers such as the 5P-7277 Voltage Tester is not recommended for today's Caterpillar electrical circuits.