HOSE AS 2214314 - Caterpillar

Illustration 1 g00524126
Remove nut (1) and the bolt from the lower end of steering shaft assembly (2) .
Illustration 2 g00524128
Remove clamp bolt (5) at the upper end of steering shaft assembly (2). Remove lever (4) and steering shaft assembly (2) as a unit from the shaft key.Note: Wipe off the fittings before any lubricant is applied.
Illustration 3 g00524168
Apply 1P-0808 Multipurpose Grease through two fittings (6) on the U-joints.Note: Make sure that steering shaft assembly (2) is fully collapsed when you lubricate the slip joint. If steering shaft assembly (2) is not fully collapsed, the slip joint may be overgreased. This could cause stiff steering, damage to internal components, difficulty in the installation of the shaft assembly, and drag between the steering shaft and the plastic shield.
Apply 5P-0960 Molybdenum Grease through one fitting (7) for the slip joint until lubricant escapes from vent hole (8) .
Illustration 4 g00524181
Install lever (4) and steering shaft assembly (2) as a unit on the shaft key. Install clamp bolt (5) .Note: Make sure that gap (A) remains between the lever and the mounting plate. Failure to maintain gap (A) during installation will cause inconsistent steering response.
The bottom yoke of steering shaft assembly (2) and the shaft of pilot valve (3) must be centered in the straight ahead position. Install the bolt and nut (1). Tighten the bolt to a torque of 55 10 N m (41 7 lb ft).