HOSE 2245757 - Caterpillar

You must read and understand the warnings and instructions contained in the Safety section of this manual before performing any operation or maintenance procedures. All PM Level 2 maintenance is to be performed at the intervals specified in the Maintenance Management Schedule for the power rating of the engine being maintained.Before proceeding with PM Level 2 maintenance, perform all PM Level 1 and Daily maintenance requirements.Engine
Steam Clean
Accumulated grease and oil on an engine is a fire hazard. Keep your engine clean. Remove debris and fluid spills each time a significant quantity accumulates on the engine.
Steam cleaning the engine is a recommended preventive maintenance practice. It provides for easy detection of oil and coolant leaks. Repairing an oil or coolant leak upon detection may save money by avoidance of major repairs that could result from low oil or coolant levels.Steam cleaning the engine as recommended will also improve the engine's heat transfer characteristics which can improve engine efficiency.Turbocharger
Inspect/Check
1. Remove the exhaust outlet piping and inlet piping from the turbocharger.2. Turn the turbine and compressor wheel by hand.3. The assembly should turn freely.4. Inspect the turbine wheel and compressor wheel for contact with the turbocharger housing.5. There should NOT be any visible signs of contact between the turbine or compressor wheel and the turbocharger housing. When installing or replacing V-band clamps, position the gap (tightening screw) down if possible so any water will drain away.6. Visually check for oil leaks.
Turbocharger bearing failures can cause large quantities of oil to enter the air intake and exhaust systems. Loss of engine lubricant can result in serious engine damage. Minor leakage of a turbocharger housing under extended low idle operation will not cause problems as long as no turbocharger bearing failure occurred.When a turbocharger bearing failure is accompanied by a significant engine performance loss (exhaust smoke or engine speed up at no load), DO NOT continue engine operation until the turbocharger is repaired or replaced.
If maintenance is required, refer to PM Level 3 in this publication for turbocharger service options.Engine Mounts
Inspect/Check
Front engine mount shown.Caterpillar recommends inspecting the engine mounts for proper bolt torque. This will prevent excessive engine vibration caused from deterioration and/or improper mounting. See your Service Manual or OEM truck manufacturer for recommended torque values.Vibration Damper
Inspect/Check
Damage to, or failure of, the damper will increase torsional vibrations and result in damage to the crankshaft and other engine components. A deteriorating vibration damper will cause excessive gear train noise at variable points in the speed range. The vibration damper can have a visual wobble (movement to the front and rear when in rotation) on the outer ring. This does not mean a replacement is necessary since some wobble of the outer ring is normal. To see if the amount of wobble is acceptable, or replacement is necessary, check the damper with the procedure in the Testing and Adjusting section of the Service Manual.The vibration damper has marks on the hub (1) and ring (2). These marks will indicate the condition of the