HOSE AS 2266375 - Caterpillar

Preliminary Test
Testing and Adjusting, "Relief Valve (Pilot) - Test and Adjust"
Testing and Adjusting, "Solenoid Valve (Proportional Reducing) - Calibrate (Power Shift Pressure)"
Testing and Adjusting, "Solenoid Valve (Proportional Reducing) - Calibrate (Negative Flow Control)"Required Tools
Illustration 1 g02571852
Tooling (A) 198-4240 Digital Pressure Indicator Gp
Table 1
Tool Item Qty Part Number Description
A 198-4240 Digital Pressure Indicator Gp
A1 1 198-4234 Indicator
A2 1 198-4237 Pressure Sensor 3447 kPa (500 psi)
A3 1 198-4236 Extension Cable Machine Preparation
Position the machine on level ground.
Stop the engine
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "System Pressure - Release".
Illustration 2 g02141845
(1) Pressure tap for the proportional reducing valve (boom regeneration valve)
(2) Pilot manifold
(3) Panel
Illustration 3 g03396939
Heavy lift solenoid (if equipped)
(1) Pressure tap for the proportional reducing valve (boom regeneration valve)
(2) Pilot manifold
(3) Panel
(4) Pressure tap for the heavy lift solenoid
Connect a 3447 kPa (500 psi) pressure sensor to the pressure tap for the boom regeneration valve. The pressure tap for the boom regeneration valve is located below the main control valve. The pressure tap can be accessed through panel (3). Calibration Procedure
Start the engine.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Place the hydraulic activation lever in the UNLOCK position.
Place the machine implements on the ground at maximum reach.
Enter the service mode. Input the password "9992".
Illustration 4 g02550247
Select "Boom Down Regen Valve" from the "Calibrations" menu.
Press the OK key in order to start the calibration. The engine RPM will automatically drop to the equivalence of engine speed dial 1.
Confirm the notes on the monitor display. Set up the test conditions in accordance with the instructions. Press the OK key.
Move the joystick for BOOM DOWN to the full down position and hold the joystick in this position.
Illustration 5 g02550277
Use the arrows to adjust the pressure until the pressure reading for the boom regeneration valve is at 500 50 kPa (73 7 psi). Press the OK key.
Move the joystick for BOOM DOWN to the NEUTRAL position.
Confirm notes on the monitor display. Set up the test conditions in accordance with the instructions. Press the OK key.
Move the joystick for BOOM DOWN to the full down position and hold the joystick in this position.
Illustration 6 g02550318
Use the arrows to adjust the pressure until the pressure reading for the boom regeneration valve is at 2500 50 kPa (363 7 psi). Press the OK key.
Move the joystick for BOOM DOWN to the NEUTRAL position.
Illustration 7 g02550516
If calibration was successful and no errors occurred, the display will indicate that the calibration is complete.
Illustration 8 g02550596
The "Error" screen will be displayed on the monitor if an error occurs. The process of calibration will not be saved and the process must be restarted.