HOSE GP-HYDRAULIC 2363212 - Caterpillar

Illustration 1 g01410180
Connectors for the ITSM (typical example) (1) Connectors for the harness to the exhaust temperature sensors (2) Integrated Temperature Sensing Module (ITSM) (3) Connectors for the harness to the terminal box for the master ECM
Disconnect harness connectors (1) and (3) from the ITSM.
Illustration 2 g01592061
Mounting hardware for the ITSM (4) Nut (5) Ground strap (6) Washer (7) Mounting group (8) Grounding studNote: One of the mounts for the ITSM has a ground strap that is attached between the nut and the washer. Remove any paint or buildup of debris from the mounting location that is for the ITSM or the mounting group in order to ensure that a good ground connection is made.
Remove the 4 nuts (4) and washers (5) from mounting groups (7) of the ITSM. Ground strap (6) must also be detached from one of the studs.Note: The mounting groups (7) for the ITSM are held in place on the mounting studs. The rubber grommets of the mounting groups help to reduce vibration. The grommets may fall when the ITSM is removed. Be sure not to lose the grommets.
Remove the ITSM from the engine.
Install the replacement ITSM onto the engine.
Use the mounting hardware to install the new ITSM. Be sure to install ground strap (6) .Note: Ensure that the nut for the grounding stud (8) is tight.Check the mounting hardware and the ITSM for correct installation. A properly installed ITSM will move slightly on the rubber grommets. If the ITSM cannot move slightly on the grommets, check that the washers and grommets are positioned correctly.
Install connectors (1) and (3) to the ITSM.
Program the configuration parameters and the monitoring system parameters into the replacement ITSM.
Restore the electrical power to the engine.
Set the engine control to the STOP position.
Select "File/Select ECM" from the drop-down menu of Cat ET.
Select the "Replacement ITSM" and click "OK".
Select "Service/Copy Configuration/ECM Replacement" from the drop-down menu. Click "OK" on the window.
Select "Program ECM" from the lower left corner of the screen. Select the replacement ITSM and click "OK".
After the loading is complete, a window with the message "Programming Complete" will appear. Select "OK".Note: When you program a new ITSM, factory passwords are not required. Also, the ITSM does not require calibration.